2458-000-G911-9 BTC Electronic Components, 2458-000-G911-9 Datasheet - Page 14

• Manufacturer Part Number: 2458-000-G911-9
• Description: Ssmc Connectors
• Manufacturer: BTC Electronic Components

Available from
BTC Electronic Components, Inc.
2) Flare cut end of braid slightly by rotating dielectric. Insert cable into rear of
3) Slide crimp sleeve forward until flush with clamp shoulder; crimp as close to shoulder as
4) Insert prepared cable into back of body. Slide nut forward and tighten to 25-50 inch ounces
Code
2) Insert cable into rear of body, with all braid wires on outside of crimp tail. Push
A/01
Code
B/01
backnut/crimp tail, with all braid wires on outside of crimp tail. Slide insulator over
cable dielectric until it is flush with front of backnut, and cable insulation bottoms inside
insulator. Slide contact onto center conductor, with contact shoulder flush with front of
insulator. Solder contact to center conductor.
possible. (see page 15 for hex die sizes).
torque. Shrink heat-shrink tubing (if supplied) with hot-air gun.
cable in until end of braid touches connector body shoulder and center conductor
rests in contact slot.
Slide crimp sleeve forward until flush with body and crimp (see below for hex die
sizes). (For solder-type connectors, solder braid to body and sleeve through hole in
sleeve.)
Solder center conductor into contact slot, assemble insulator disc (if supplied),
then press cap into body until seated. Shrink heat-shrink tubing (if supplied) with
hot-air gun.
DELTA ELECTRONICS MANUFACTURING
Cable Trim Codes
.150
Cable Trim Codes
.150
A
A
.300
.187
B
B
( 978 ) 927-1060
M22520/5-01
.125
.050
C
C
Crimp Tools for Flexible Cable
Frame only—P/N M22520/5-01—Use with interchangeable dies listed below.
SSMC Cable Assembly Instructions
1) Trim cable per chart.
Cable Group*
•
1) Trim cable per chart. Slide crimp
Assembly Procedure A
Assembly Procedure B
1-800-526-2828 or 919-556-8900
FAX ( 978 ) 922-6430
Slide crimp sleeve and
heat-shrink tubing (if
supplied) onto cable.
sleeve and heat-shrink tubing (if
supplied) onto cable.
10
11
9
.128 hex, .400 wide
.151 hex, .400 wide
.105 hex, .400 wide
Hex Die Size
•
www.deltarf.com
Crimp or solder sleeve
Heat-shrink tubing
M22520/5-35
M22520/5-37
M22520/5-33
Crimp sleeve
Die Set P/N
Heat-shrink tubing
A
B
Crimp sleeve
www.btcelectronics.com
C
A
Press cap in
until seated
B
Solder center
conductor to
contact
Insulator
(if supplied)
Backnut/Crimp tail
Cap
Body assembly
Closure
Solder
B
B
B
C
14