T1504 ACER, T1504 Datasheet - Page 28

• Manufacturer Part Number: T1504
• Description: COLOR TFT LCD MODULE
• Manufacturer: ACER

B
C
D
A
EDIT
DESIG.
1 6 . W A R R A N T Y
1 7 . P R E C A U T I O N S
DATE
The warranty period is one year after manufacturing. Products which fail during this period are
repaired or replaced without charge, unless the failure is caused by user.
Adhere to the following precautions to properly use this LCD module.
( 1 ) A p p l i c a t i o n
( 2 ) H a n d l i n g o f L C D p a n e l
① D o n o t a p p l y a n y s t r o n g m e c h a n i c a l s h o c k t o t h e L C D p a n e l .
② D o n o t p r e s s h a r d o n t h e L C D p a n e l s u r f a c e .
③ D o n o t s c r a t c h t h e p o l a r i z e r f i l m o n t h e L C D p a n e l s u r f a c e .
④ D o n o t p l a c e o r c o n t a c t o b j e c t s o n t h e d i s p l a y s u r f a c e f o r a l o n g p e r i o d o f t i m e .
The information contained in this document are not intended for the use of this LCD as a
equipment which requires extremely high reliability such as aerospace equipment, nuclear
control systems and medical for life support.
DESIG.
Since the LCD panel is made of glass, excessive shock may damage the panel or cause a
malfunction.
In the LCD panel, the gap between two glass plates is kept precisely and uniformly to
maintain display’s characteristics and reliability. If this panel is pressed hard, the
following troubles occurs.
Problem (a) returns to normal after a while. Problem (b) returns to normal if power is
shut off once then turned on again.
However these operations should be avoided to insure reliability.
•Do not press or rub the display surface with a hard tool, pincet, etc.
•For handling, use cotton or conductive gloves so that the display surface is not stained.
•For If the display surface is stained by dust or dirt, clean it as follows with a soft cloth
[Dust] Wipe off with a soft cloth. (do not rub.)
[Dirt ] Wipe off lightly with a soft cloth after soaking in the clear water and squeezing
•If saliva or water drops are left for long time, it may deform partial deformation or
•Do not allow oil to adhere to the module, since the cleaning of oil is difficult.
That’s because this may make some parts of the LCD module distorted and the display
quality may decline.
1
(deer skin, etc.)
discolored. Wipe off immediately in the same way as for dirt.
(a) Ununiformity of color
(b) Orientation of liquid crystal becomes disordered
CHECK
hard out of water drops. Only if the dirt is hardly wiped off, use isopropyl alcohol
or ethanol.
Be careful not to splash the water or the solvent and water penetrated between
the polarizer and the LCD panel.
Do not use solvents such as ketone (acetone, etc.) and aromatics (xylene, toluene,
etc.)
CHECK
APPR.
DESCRIPTION
APPR.
Tech Bes LCD-00033
FLC38XGC6V-06
【FLC38XGC6V-06】
27
CUST.
A
B
C
D
E
F