CT2-PL1PFTD33C ETC-unknow, CT2-PL1PFTD33C Datasheet - Page 4

• Manufacturer Part Number: CT2-PL1PFTD33C
• Description: Oc-12 Transceiver Multirate,1310 1550
• Manufacturer: ETC-unknow

4
CT2 Electrical Pad Layout
Transceiver Pin Descriptions
Pin
TD
TDb
RD
RDb
Rate_select
TxDIS
LOS
Tx_fault
MOD_DEF(0)
MOD_DEF(1)
MOD_DEF(2)
VccR, VccT
VeeR, VeeT
Description
Un-clocked, multirate, differential serial bit stream (155 Mb/s to 622 Mb/s) used to drive the optical transmitter.
Internally AC coupled and terminated via internal 100 Ω differential impedence.
Differential received electrical signal capable of detecting 155 Mb/s to 622 Mb/s bit patterns.
The differential pair is internally biased and AC coupled. This signal requires 100 Ω external differential termination.
Internally monitored and available for future use. Can be customized for specific applications.
Transmitter Disable Input. A logic HIGH on this input pin disables the transmitter's laser so that there is no optical
output. If left open the transmitter will be disabled.
Loss of Signal (Open Collector). A logic HIGH on this output indicates an incoming signal level that is less than
-32 dBm but no greater than -38 dBm. LOS shall deassert (logic LOW) when a 3 dB (maximum), 0.5 dB (minimum)
hysteresis is obtained.
Transmitter fault (Open collector). A logic HIGH indicates that the transmitter is in a fault condition.
MOD_DEF(0) is internally grounded to indicate the presence of the module. Must be pulled-up on host board with
a 10 KΩ resistor.
MOD_DEF(1) is the clock of the 2 wire interface for module monitoring.
MOD_DEF(2) is the data line of the 2 wire interface for module monitoring.
Receiver, Transmitter power supply, respectively
Receiver, Transmitter ground, respectively. The chassis ground and circuit ground isolation is configurable.
20
19
18
17
16
15
14
13
12
11
Top of Board
TD-
TD+
VccT
VccR
VeeR
RD-
VeeR
VeeT
VeeT
RD+
OC-12 SFP TRANSCEIVER
1
2
3
4
5
6
7
8
9
10
Bottom of Board (As Viewed
through Top of Board)
VeeT
Tx Disable
MOD-DEF(2)
MOD-DEF(1)
MOD-DEF(0)
Rate Select
LOS
VeeR
VeeR
Tx Fault