UMC3 ON Semiconductor, UMC3 Datasheet - Page 10

• Manufacturer Part Number: UMC3
• Description: Dual Common Base-Collector Bias Resistor Transistors
• Manufacturer: ON Semiconductor

total design. The footprint for the semiconductor packages
must be the correct size to insure proper solder connection
the pad size. This can vary from the minimum pad size for
soldering to the pad size given for maximum power
dissipation. Power dissipation for a surface mount device is
determined by T
temperature of the die, R
the device junction to ambient; and the operating
temperature, T
sheet, P
ratings table on the data sheet. Substituting these values
into the equation for an ambient temperature T
temperature of the device. When the entire device is heated
to a high temperature, failure to complete soldering within
a short time could result in device failure. Therefore, the
following items should always be observed in order to
minimize the thermal stress to which the devices are
subjected.
Surface mount board layout is a critical portion of the
The power dissipation of the SOT–353 is a function of
The values for the equation are found in the maximum
The melting temperature of solder is higher than the rated
Always preheat the device.
The delta temperature between the preheat and
soldering should be 100 C or less.*
When preheating and soldering, the temperature of the
leads and the case must not exceed the maximum
temperature ratings as shown on the data sheet. When
using infrared heating with the reflow soldering
method, the difference should be a maximum of 10 C.
D
can be calculated as follows:
INFORMATION FOR USING THE SOT–353 SURFACE MOUNT PACKAGE
MINIMUM RECOMMENDED FOOTPRINTS FOR SURFACE MOUNTED APPLICATIONS
A
. Using the values provided on the data
J(max)
P
D
=
, the maximum rated junction
T
JA
J(max)
, the thermal resistance from
R
JA
– T
A
UMC2NT1, UMC3NT1, UMC5NT1
0.5 mm (min)
É É É
É É É
É É É
É É É
É É É
É É É
É É É
SOT–353 POWER DISSIPATION
SOLDERING PRECAUTIONS
A
of 25 C,
http://onsemi.com
SOT–353
1.9 mm
10
interface between the board and the package. With the
correct pad geometry, the packages will self align when
subjected to a solder reflow process.
one can calculate the power dissipation of the device which
in this case is 150 milliwatts.
of the recommended footprint on a glass epoxy printed
circuit board to achieve a power dissipation of 150
milliwatts. There are other alternatives to achieving higher
power dissipation from the SOT–353 package. Another
alternative would be to use a ceramic substrate or an
aluminum core board such as Thermal Clad . Using a
board material such as Thermal Clad, an aluminum core
board, the power dissipation can be doubled using the same
footprint.
* Soldering a device without preheating can cause
excessive thermal shock and stress which can result in
damage to the device.
The 833 C/W for the SOT–353 package assumes the use
The soldering temperature and time should not exceed
260 C for more than 10 seconds.
When shifting from preheating to soldering, the
maximum temperature gradient should be 5 C or less.
After soldering has been completed, the device should
be allowed to cool naturally for at least three minutes.
Gradual cooling should be used as the use of forced
cooling will increase the temperature gradient and
result in latent failure due to mechanical stress.
Mechanical stress or shock should not be applied
during cooling.
É É É
É É É
É É É
É É É
É É É
P
D
=
150 C – 25 C
833 C/W
= 150 milliwatts