TDA9989 Philips Semiconductors, TDA9989 Datasheet - Page 21
TDA9989
Manufacturer Part Number
TDA9989
Description
150 MHz Pixel Rate HDMI 1.3a Transmitter
Manufacturer
Philips Semiconductors
Datasheet
1.TDA9989.pdf
(48 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
TDA9989ET/C1,518
Manufacturer:
NXP Semiconductors
Quantity:
10 000
Company:
Part Number:
TDA9989ET/C1,551
Manufacturer:
NXP Semiconductors
Quantity:
10 000
Company:
Part Number:
TDA9989ET/C1,557
Manufacturer:
NXP Semiconductors
Quantity:
10 000
www.DataSheet4U.com
NXP Semiconductors
TDA9989_2
Product data sheet
7.8.1 S/PDIF
7.8.2 I
7.7 Downsampler
7.8 Audio input format
Remark: Gamut-related metadata is an HDMI 1.3a feature.
This block works only with YCbCr input format; the filters downsample the Cb and Cr
signals by a factor of 2. A delay is added on the Y channel, which corresponds to the
pipeline delay of the filters, to put the Y channel in phase with the Cb-Cr channel.
TDA9989 is compatible with the following audio features described in the HDMI 1.3a
specification:
The TDA9989 can carry audio in I
S/PDIF format through one audio pin named AP1. S/PDIF or I
selected via the I
I
Table 16.
All audio ports are LV-CMOS 1.8 V compatible and LV-CMOS 3.3 V tolerant. It is possible
to map an internally unused port to internal ground via I
page 00h for both audio and clock inputs.
In this format TDA9989 supports 2-channel uncompressed PCM data (IEC 60958) layout
0, or compressed bit stream up to 8 multi channels (Dolby Digital, DTS, AC3 etc.) layout 1.
The TDA9989 is able to recover the original clock from the S/PDIF signal (no need of
external clock).
There is one I
carried. The I
select and serial clock.
Typical waveforms for the I
Audio port
AP0
AP1
ACLK
2
2
•
•
S-bus.
S-bus
S/PDIF
I
2
S-bus up to two stereo channels
Table 16
Audio port configuration
2
2
S-bus input interface receives an I
S-bus stereo input, which enables 2 uncompressed audio channels to be
2
Input configuration
S/PDIF
-
S/PDIF input
-
shows the audio port allocation and
C-bus. Only one audio format can be used at a time: either S/PDIF or
Rev. 02 — 11 June 2009
2
S-bus signals at 64f
2
S-bus format (one stereo to two stereo channels) or in
HDMI 1.3a transmitter with CEC support
s
2
are given by
S-bus signal including serial data, word
Section 7.8.3
2
C-bus with ENA_AP register on
I
WS (word select)
I
SCK (I
Figure
2
2
2
S-bus format can be
S-bus
S-bus channel 0
2
gives more details.
S-bus clock)
13.
TDA9989
© NXP B.V. 2009. All rights reserved.
21 of 48