NCP5010 ON Semiconductor, NCP5010 Datasheet - Page 2

• Manufacturer Part Number: NCP5010
• Description: Boost Converter
• Manufacturer: ON Semiconductor

PIN FUNCTION DESCRIPTION
PIN
A1
B1
C1
A2
C2
A3
B3
C3
PIN NAME
AGND
PGND
CTRL
V
SW
V
NC
FB
OUT
IN
POWER
POWER
POWER
POWER
POWER
ENABLE
INPUT
INPUT
TYPE
N/A
C
4.7 mF 0603
X5R 6.3V
System ground for the analog circuitry. A high quality ground must be provided to avoid spikes and/
or uncontrolled operations. This pin is to be connected to the PGND pin.
Power Supply Input. A ceramic capacitor with a minimum value of 1 mF/6.3 V (X5R or X7R) must be
connected to this pin. This capacitor should be placed as close as possible to this pin. In addition,
one end of the external inductor is to be connected at this point.
DC−DC converter output. This pin should be directly connected to the load and a low ESR
(<30 mW) 1 mF (min) 25 V bypass capacitor. This capacitor is required to smooth the current flowing
into the load, thus limiting the noise created by the fast transients present in this circuit. Since this is
a current regulated output, this pin has over voltage protection to protect from open load conditions.
Care must be taken to avoid EMI through the PCB copper tracks connected to this pin.
An Active High logic level on this pin enables the device. A built−in pulldown resistor disables the
device if the pin is left open. This pin can also be used to control the average current into the load
by applying a low frequency PWM signal. If a PWM signal is applied, the frequency should be high
enough to avoid optical flicker but be no greater than 1 kHz.
Power switch connection for inductor. Typical application will use a coil from 10 mH to 22 mH and
must be able to handle at least 350 mA. If the desired output power is above 300 mW, the inductor
should have a DCR < 1.4 W.
Not Connected
Feedback voltage input used to close the loop by means of a sense resistor connected between the
primary LED branch and the ground. The output current tolerance is depends upon the accuracy of
this resistor and a ±5% or better accuracy metal film resistor is recommended. An analog dimming
signal can be applied to this point to reduce the output current. Please refer to the application
section for additional details.
Power ground. A high quality ground must be used to avoid spikes and/or uncontrolled operation.
Care must be taken to avoid high−density current flow in a limited PCB copper track. This pin is to
be connected to the AGND pin.
in
V
bat
NCP5010
2.7 to 5.5 V
A2
A3
Figure 2. Typical Application Circuit
CTRL
NC
http://onsemi.com
NCP5010
V
L1
22 mH
OUT
2
C1
C
1 mF 0805
X5R 25V
DESCRIPTION
out
R
24
fb
LED
LED