VT400 PerkinElmer Optoelectronics, VT400 Datasheet - Page 40
![no-image](/images/no-image-200.jpg)
VT400
Manufacturer Part Number
VT400
Description
Photoconductive Cells and Analog Optoisolators (vactrols)
Manufacturer
PerkinElmer Optoelectronics
Datasheet
1.VT400.pdf
(76 pages)
Characteristics of Analog Optical Isolators
Some major characteristics of Johnson noise are that it is:
1. Independent of frequency and contains a constant power density
2. Temperature dependent, increasing with increased temperature.
3. Dependent on photocell resistance value.
Johnson noise is defined by the following equation:
where:
A second type of noise is “shot” noise. When a direct current flows
through a device, these are some random variations superimposed on
this current due to random fluctuations in the emission of electrons due
to photon absorption. The velocity of the electrons and their transit
time will also have an effect.
“Shot” noise is:
1. Independent of frequency.
2. Dependent upon the direct current flowing through the photocell.
Shot noise is defined by the following equation:
where:
per unit of bandwidth.
I
k = Boltzmann’s constant, 1.38 x 10
T = temperature, degrees Kelvin
R = photocell resistance
BW = bandwidth of interest, Hertz
I
e = electron charge, 1.6 x 10
I
BW = bandwidth of interest, Hertz
NJ
NS
dc
= dc current, amps
= Johnson noise current, amps RMS
= shot noise current, amps RMS
I
NJ
I
NS
=
=
4kTBW
2eI
-19
dc
BW
-23
R
35
The third type of noise is flicker of 1/f noise. The source of 1/f noise is
not well understood but seems to be attributable to manufacturing
noise mechanisms. Its equation is as follows:
where:
Unlike thermal or shortnoise, flicker noise has 1/f spectral density and
in the ideal case for which it is exactly proportional to
termed “pink noise”. Unfortunately, the constant (K) can only be
determined empirically and may vary greatly even for similar devices.
Flicker noise may dominate when the bandwidth of interest contains
frequencies less than about 1 kHz.
In most AOI circuits noise is usually so low that it is hardly ever
considered. One notable exception is in applications where large
voltages are placed across the cell. For a typical isolator, it takes 80 to
100V across the photocell before the noise level starts to increase
significantly.
Distortion
Analog Optical Isolators have found wide use as control elements in
audio circuits because they possess two characteristics which no other
active semiconductor device has: resistance output and low harmonic
distortion. AOIs often exhibit distortion levels below -80 db when the
voltage applied to the photocell output is kept below 0.5V.
Figure 3 shows the typical distortion generated in typical AOIs. The
distortion depends on the operating resistance level as well as the
applied voltage. The minimum distortion or threshold distortion shown
in Figure 3 is a second harmonic of the fundamental frequency. The
actual source of this distortion is unknown, but may be due to some
type of crossover nonlinearity at the original of the I-V curve of the
photocell.
I
K = a constant that depends on the type of material
I
BW = bandwidth of interest, Hertz
f = frequency, Hertz
NF
dc
= dc current, amps
= flicker noise, amps
and its geometry
I
NF
=
KI
dc
BW f
1 f
, it is