RB5C396 Ricoh Corporation, RB5C396 Datasheet - Page 51

• Manufacturer Part Number: RB5C396
• Description: PC Card Controller Compliant With Pcmcia 2.1/jeida 4.2
• Manufacturer: Ricoh Corporation

1.2 INTR# Pin
2. Connections to System Bus
2.1 IOCS16#, MEMCS16#, ZEROWS#, and IOCHRDY Pins
pull-up resistor in the absence of any pull-up resistor provided on the ISA bus. These resistors are designed to drive
a 300½ pull-up resistor (for the IOCS16#, MEMCS16#, and ZEROWS# pins) and a 1k½ pull-up resistor (for the
IOCHRDY).
clock pulse upon transition from low level to high impedance as shown in the figure below. Originally, strict regula-
tion of the pull-up resistor for these open-drain output pins is required for the fast rising edge of their pin signals but
not recommended in consideration of current consumption.
of current consumption without strict regulation of the pull-up resistor to such a degree as not to affect any other
system.
2.2 CS# Pin
RF5C396 and not directly related to access to the card windows.
access to the control registers. (For details, see “6. Access to Internal Registers” in “FUNCTIONAL DESCRIP-
TION”.)
ing the address signals output from the SA15 to the SA1 (or the SA23 to the SA16 for some systems) for input with
negative logic to the CS# pin.
an I/O address of 03E0h or 03E1h. In this case, the CS# pin must receive a signal input which becomes active only
when the SA15 to SA10 pins are all caused to transition to “L”. This is because the status of the CE# pin affects the
Power Down Mode (specified by bit0 in the Global Control Register (Index : 1Eh)). When the Power Down Mode is
not in use, therefore, the CE# pin should be held at “L”.
isters. Pulling up and down the INTR# pin specifies internal decoding and external decoding, respectively. For
details, see “6. Access to Internal Registers” in “FUNCTIONAL DESCRIPTION”.
Basically, connections to the ISA bus only require connections to corresponding bus pins.
The IOCS16#, MEMCS16#, ZEROWS#, and IOCHRDY pins are open-drain output pins which require an external
The ZEROWS# and IOCHRDY pins are also caused to transition to “H” level for the maximum duration of one
For the RF5C296 and the RF5C396, such unique designs of the ZEROWS# and IOCHRDY pins allow restriction
The CS# pin is intended to determine an I/O address for access to the control registers for the RF5C296 and the
As described before, either external decoding or internal decoding can be used to determine an I/O address for
When external decoding is used, an I/O address for access to the control registers can be determined by decod-
When internal decoding is used, access to the internal registers is conditional upon the CS# pin held at “L” and
The INTR# pin determines whether to use external decoding or internal decoding for access to the internal reg-
SYSCLK
IOCHRDY
ZEROWS#
T21
One clock pulse
RF5C296/RF5C396L/RB5C396/RF5C396
47