AN2777 Freescale Semiconductor / Motorola, AN2777 Datasheet - Page 7

Manufacturer Part Number

AN2777

Description

Tango3 Monitor for the MC9S08RG60 MCU

Manufacturer

Freescale Semiconductor / Motorola

Datasheet

1.AN2777.pdf (18 pages)

To start the monitor:

Freescale Semiconductor

1. Connect the Tango3 RF Module to connector J1 on the Mc9S08RG60 Demo Board. Pin 1 on each

2. Connect an antenna to the Tango3 RF module.

3. Install power select (PWR_SEL) jumpers 1 and 2 on the MC9S08RG60 Demo Board. Both jumpers

4. Connect the serial port connector on the MC9S08RG60 Demo Board to a PC comm. port using a

5. Connect a 9V power supply or battery to the power connector on the MC9S08RG60 Demo Board.

6. Configure the terminal program for 9600 baud, eight data bits, no parity, one stop bit, no flow

7. Connect the MC9S08RG60 Demo Board to the PC comm. port using the 9-pin D connector.

8. Start the terminal program. (In Hyperterminal, click the 'Connect' icon on the toolbar at the top of

9. Connect power to the MC9S08RG60 Demo Board.

board should be aligned.

must be installed.

9-pin straight-through serial cable.

(See

control. (If using Hyperterminal, use the Tango3Monitor.ht setup file.)

the screen.)

Figure 3

Tango3 RF modules are available in a range of frequencies; each is

supplied with an appropriate antenna.

for a reference setup.)

Figure 5. Terminal Program Configuration

Tango3 Monitor for the MC9S08RG60 MCU, Rev. 0

NOTE

Using the Software