MIC37302 Micrel Semiconductor, MIC37302 Datasheet - Page 9

• Manufacturer Part Number: MIC37302
• Description: 3.0A/ LOW VOLTAGE UCAP LDO REGULATOR
• Manufacturer: Micrel Semiconductor

Minimum Load Current
The MIC37300/01/02 regulator is specified between finite
loads. If the output current is too small, leakage currents
dominate and the output voltage rises. A 10mA minimum load
current is necessary for proper operation.
Error Flag
The MIC37301 features an error flag circuit that monitors the
output voltage and signals an error condition when the
voltage is 5% below the nominal output voltage. The error flag
is an open-collector output that can sink 10mA during a fault
condition.
Low output voltage can be caused by a number of problems,
including an overcurrent fault (device in current limit) or low
input voltage. The flag is inoperative during overtemperature
shutdown.
Enable Input
The MIC37301/37302 also features an enable input for on/off
control of the device. Its shutdown state draws “zero” current
(only microamperes of leakage). The enable input is TTL/
CMOS compatible for simple logic interface, but can be
connected up to V
15 A.
November 2003
MIC37300/37301/37302
IN
. When enabled, it draws approximately
9
Adjustable Regulator Design
The MIC37302 allows programming the output voltage any-
where between 1.24V and the 5.5V maximum operating
rating of the family. Two resistors are used. Resistors can be
quite large, up to 1M , because of the very high input
impedance and low bias current of the sense comparator.
The resistor values are calculated by:
Where V
component definition. Applications with widely varying load
currents may scale the resistors to draw the minimum load
current required for proper operation (see above).
Figure 2. Adjustable Regulator with Resistors
OUT
SHUTDOWN
ENABLE
is the desired output voltage. Figure 2 shows
R1 R2
V
IN
V
OUT
IN
EN
MIC37302
1.240
V
1.240V 1
GND
OUT
OUT
ADJ
1
R2
R1
R1
R2
C
M0307-112003
OUT
V
OUT
Micrel