LM3S2608 Luminary Micro, Inc, LM3S2608 Datasheet - Page 27

• Manufacturer Part Number: LM3S2608
• Description: Lm3s2608 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

July 26, 2008
■
■
■
■
–
–
UART
–
–
–
–
–
–
–
–
ADC
–
–
–
–
–
–
–
Analog Comparators
–
–
–
I
–
–
2
C
Programmable data frame size from 4 to 16 bits
Internal loopback test mode for diagnostic/debug testing
Two fully programmable 16C550-type UARTs with IrDA support
Separate 16x8 transmit (TX) and 16x12 receive (RX) FIFOs to reduce CPU interrupt service
loading
Programmable baud-rate generator allowing speeds up to 3.125 Mbps
Programmable FIFO length, including 1-byte deep operation providing conventional
double-buffered interface
FIFO trigger levels of 1/8, 1/4, 1/2, 3/4, and 7/8
Standard asynchronous communication bits for start, stop, and parity
False-start-bit detection
Line-break generation and detection
Single- and differential-input configurations
Eight 10-bit channels (inputs) when used as single-ended inputs
Sample rate of 500 thousand samples/second
Flexible, configurable analog-to-digital conversion
Four programmable sample conversion sequences from one to eight entries long, with
corresponding conversion result FIFOs
Each sequence triggered by software or internal event (timers, analog comparators, or GPIO)
On-chip temperature sensor
Two independent integrated analog comparators
Configurable for output to: drive an output pin, generate an interrupt, or initiate an ADC sample
sequence
Compare external pin input to external pin input or to internal programmable voltage reference
Two I
Master and slave receive and transmit operation with transmission speed up to 100 Kbps in
Standard mode and 400 Kbps in Fast mode
2
C modules
Preliminary
LM3S2608 Microcontroller
27