CLAA141WB02A CHUNGHWA PICTURE TUBES, CLAA141WB02A Datasheet - Page 21

• Manufacturer Part Number: CLAA141WB02A
• Description: Display Module
• Manufacturer: CHUNGHWA PICTURE TUBES

CPT
10.1 ASSEMBLY PRECAUTION
10.2 OPERATING PRECAUTIONS
CPT Confidential
(1) Please use the mounting hole on the module side in installing and do not beading or
(2) Please design display housing in accordance with the following guidelines.
(3) Please do not push or scratch LCD panel surface with any-thing hard. And do not soil
(4) Please do not press any parts on the rear side such as source TCP, gate TCP, control
(5) Please wipe out LCD panel surface with absorbent cotton or soft clothe in case of it being
(6) Please wipe out drops of adhesives like saliva and water on LCD panel surface
(7) Please do not take a LCD module to pieces and reconstruct it.
(8) Please do not touch metal frames with bare hands and soiled gloves. A color change of
(9) Please pay attention to handling lead wire of backlight so that it is not tugged in
(1) Please be sure to turn off the power supply before connecting and disconnecting signal
(2) Please do not change variable resistance settings in LCD module. They are adjusted to the
(3) Please consider that LCD backlight takes longer time to become stable of radiation
(4) A condensation might happen on the surface and inside of LCD module in case of sudden
(5) Please pay attention to displaying the same pattern for very long time. Image might stick
(6) Please obey the same caution descriptions as ones that need to pay attention to ordinary
LCD in assembling. And please do not drop, bend or twist LCD module in handling.
LCD panel surface by touching with bare hands. ( Polarizer film, surface of LCD panel is
easy to be flawed.)
circuit board and FPCs during handling LCD module. If pressing rear part is unavoidable,
handle the LCD module with care not to damage them.
soiled.
immediately. They might damage to cause panel surface variation and color change.
reconstructing modules may cause them not to work well.
the metal frames can happen during a long preservation of soiled LCD modules.
connecting with inverter.
input cable.
most suitable value. If they are changed, it might happen LCD does not satisfy the
characteristics specification.
characteristics in low temperature than in room temperature.
change of ambient temperature.
on LCD. If then, time going on can make LCD work well.
electronic parts.
wrenching
Keep sufficient clearance between LCD module back surface and housing when the
When some parts, such as, FPC cable and ferrite plate, are installed underneath the
Design the inverter location and connector position carefully so as not to give stress
Keep sufficient clearance between LCD module and the others parts, such as inverter
Housing case must be destined carefully so as not to put stresses on LCD all sides
and not to wrench module. The stresses may cause non-uniformity even if there is
no non-uniformity statically.
LCD module is mounted. Approximately 1.0 mm of the clearance in the design is
recommended taking into account the tolerance of LCD module thickness and
mounting structure height on the housing.
LCD module, still sufficient clearance is required, such as 0.5mm. This clearance
is, especially, to be reconsidered when the additional parts are implemented for
EMI countermeasure.
to lamp cable, or not to interface the LCD module by the lamp cable.
and speaker so as not to interface the LCD module. Approximately 1.0mm of the
clearance in the design is recommended.
20/22
CHUNGHWA PICTURES TUBES, LTD.,
www.DataSheet.net/
www.yslcd.com.tw
Resolving and
Datasheet pdf - http://www.DataSheet4U.co.kr/