DF9B-17S-1V Hirose, DF9B-17S-1V Datasheet - Page 8

• Manufacturer Part Number: DF9B-17S-1V
• Description: 1mm Pitch SMT Board to Board Connector(Standard Interface Connector Compliant with VESA FPDI-1)
• Manufacturer: Hirose

BPrecautions for Use
1. Recommended Temperature Profile (SMT)
2. Recommended Manual Soldering Condition (SMT)
3. Recommended Screen Thickness (SMT)
4. Board Warp(SMT)
5. Cleaning Condition
6. Cautions
Temperature
Note 1 : Maximum twice action is allowed under the same condition. However, the interval between
Note 2 : The temperature indicates the board surface temperature in the connector lead area.
Soldering iron temperature: 290 10 , Soldering time: Within 2 seconds
0.15mm
Maximum 0.03mm in the connector center area, based on both connector edges.
Refer to the "Nylon Connector Use Hand book".
Avoid retaining the board with the connector only, and fix the board by any other means than the connector.
Where the board is not mounted, the insertion or extraction will cause damage or deformation in contacts.
Excessive scoop insertion or extraction may result in damage.
In the manual soldering process, don't carry out flux coating which will cause a flux blister on the connector.
The color phase of this product may be slightly different from that of the forming product according to the
manufacturing lot. However, the difference doesn't affect the performance.
the first process and second actions must be maintained at the room temperature.
Preheating area 150
Soldering area
IR reflow condition
235±5
220
Preheating area
for 100 to 120 seconds
for 10 seconds max.
Min for 10 to 30 second
Soldering area
Maximum
Time
A285