AS1301 austriamicrosystems AG, AS1301 Datasheet - Page 12

• Manufacturer Part Number: AS1301
• Description: 5V/50mA Low Noise Inductorless Boost Converter
• Manufacturer: austriamicrosystems AG

www.datasheet4u.com
AS1301
Data Sheet
9 Application Information
External Component Selection
The high internal oscillator frequency of 1MHz permits the use of small capacitors for both the flying capacitors and the
output capacitors. For any given load value of the flying- and output capacitors as well as their ESR are affecting the
output voltage performance.
In general, the capacitor’s ESR is inversely proportional to its physical size. Larger capacitances and higher voltage
ratings tend to reduce ESR. The ESR is a function of the frequency too, so it must be rated at the devices operating
frequency. Another factor affecting capacitor ESR is temperature.
Note: Many capacitors have a huge capacity variation over temperature. This can be compensated by choosing a
Input and Output Capacitor Selection
It is not critical which type of input bypass capacitor C
the performance of the charge-pump. Low ESR capacitors should be used to minimize V
capacitors are recommended since they have extremely low ESR and are available in small footprints.
Input Capacitor
An 1.2µF/2.2µF input bypass low ESR capacitor such as tantalum or ceramic is recommended to reduce noise and
supply transients. During startup and mode change it supplies part of the peak input current drawn by the device.
Table 4. Recommended Input Capacitor
Output Capacitor
The output capacitor is charged to the V
duces steps in the output voltage waveform whenever the charge pump charges C
ripple voltage of VOUT. Therefore, ceramic or tantalum low ESR capacitors are recommended for C
the output voltage ripple.
Table 5. Recommended Output Capacitor
Charge-Pump Capacitor Selection
To ensure the required output current and avoid high peak currents the values of the flying capacitors C
are very critical. A 120nF capacitor is sufficient for most applications. Dependent on the operation mode the AS1301
alternately charges and discharges the C
voltage ripple, the voltage drop caused by the ESR of the flying capacitors affects the maximum available output
voltage. Therefore low ESR capacitors, e.g. tantalum or ceramic, are recommended for the flying capacitors as well.
Table 6. Recommended Charge-Pump Capacitor
www.austriamicrosystems.com
GRM21BR71A225KA01
GRM21BR71A225KA01
GRM188R71E224KA88
Part Number
Part Number
Part Number
capacitor with a better thermal coefficient or by choosing a larger nominal value to ensure proper operation
over temperature.
- A p p l i c a t i o n I n f o r m a t i o n
2.2µF
2.2µF
220nF
C
C
C
OUT
FLY1/2
TC Code Rated Voltage Dimensions (L/W/T)
TC Code Rated Voltage Dimensions (L/W/T)
TC Code Rated Voltage
X7R
X7R
voltage during pumping phase. The ESR of the output capacitor intro-
X7R
. While the ESR of the output capacitor produces part of the output
Revision 1.00
BAT
and output filter capacitor C
10V
10V
25V
Dimensions (L/W/T)
2x1.2x1.35mm
2x1.2x1.35mm
1.6x0.8x0.87mm
OUT
OUT
. These steps contribute to the
OUT
is used, but it will still affect
ripple. Multi-layer ceramic
Murata
www.murata.com
Murata
www.murata.com
Murata
www.murata.com
Manufacturer
Manufacturer
Manufacturer
OUT
FLY1
to minimize
and C
12 - 16
FLY2