AS1753 austriamicrosystems AG, AS1753 Datasheet - Page 13

• Manufacturer Part Number: AS1753
• Description: Quad SPST Analog Switches
• Manufacturer: austriamicrosystems AG

AS1751/AS1752/AS1753
Data Sheet
Notes:
1. Dimensioning and tolerancing conform to ASME Y14.5M-1994 .
2. All dimensions are in millimeters; angles in degrees.
3. N is the total number of terminals.
4. The terminal #1 identifier and terminal numbering convention shall conform to JEDEC 95 SPP-012 . Details of termi-
5. Dimension b applies to metallized terminal and is measured between 0.15 and 0.30mm from terminal tip. If one end
6. Dimensions ND and NE refer to the number of terminals on each D and E side, respectively.
7. Depopulation is possible in a symmetrical fashion.
8.
9. All variations may be constructed per
10. Refer to the Dimensions Table for a complete set of dimensions.
11. Bilateral coplanarity zone applies to the exposed heat sink slug as well as the terminals.
12. Depending on the method of lead termination at the edge of the package, pullback (L1) may be present. L minus
13. For variations with more than one lead count for a given body size and terminal pitch, each lead count for that vari-
14. NJR designates non-JEDEC registered package.
www.austriamicrosystems.com
nal #1 identifier are optional but must be located within the zone indicated. The terminal #1 identifier may be either
a mold or marked feature.
of the terminal has the optional radius, the b dimension should not be measured in that radius area.
or rectangle shape per dimensions D and E.
Figure 19
L1 to be ≥ 0.33mm.
ation is denoted by a dash number (e.g., -1 or -2).
- A p p l i c a t i o n I n f o r m a t i o n
is shown for illustration only and does not represent any specific variation.
Figure
19, however variations may alternately be constructed between square
Revision 1.41
www.DataSheet4U.com
13 - 16