LTC3835-1 Linear Technology, LTC3835-1 Datasheet - Page 12

• Manufacturer Part Number: LTC3835-1
• Description: Low IQ Synchronous Step-Down Controller
• Manufacturer: Linear Technology

www.datasheet4u.com
LTC3835-1
Accepting larger values of ΔI
inductances, but results in higher output voltage ripple
and greater core losses. A reasonable starting point for
setting ripple current is ΔI
ΔI
The inductor value also has secondary effects. The tran-
sition to Burst Mode operation begins when the average
inductor current required results in a peak current below
10% of the current limit determined by R
inductor values (higher ΔI
lower load currents, which can cause a dip in effi ciency in
the upper range of low current operation. In Burst Mode
operation, lower inductance values will cause the burst
frequency to decrease.
Inductor Core Selection
Once the value for L is known, the type of inductor must
be selected. High effi ciency converters generally cannot
afford the core loss found in low cost powdered iron cores,
forcing the use of more expensive ferrite or molypermalloy
cores. Actual core loss is independent of core size for a
fi xed inductor value, but it is very dependent on inductance
selected. As inductance increases, core losses go down.
Unfortunately, increased inductance requires more turns
of wire and therefore copper losses will increase.
Ferrite designs have very low core loss and are preferred
at high switching frequencies, so design goals can con-
centrate on copper loss and preventing saturation. Ferrite
core material saturates “hard,” which means that induc-
tance collapses abruptly when the peak design current is
exceeded. This results in an abrupt increase in inductor
ripple current and consequent output voltage ripple. Do
not allow the core to saturate!
APPLICATIONS INFORMATION
12
L
occurs at the maximum input voltage.
L
L
) will cause this to occur at
= 0.3(I
L
allows the use of low
MAX
). The maximum
SENSE
. Lower
Power MOSFET and Schottky Diode (Optional)
Selection
Two external power MOSFETs must be selected for each
controller in the LTC3835-1: One N-channel MOSFET for
the top (main) switch, and one N-channel MOSFET for the
bottom (synchronous) switch.
The peak-to-peak drive levels are set by the INTV
This voltage is typically 5V during start-up (see EXTV
Pin Connection). Consequently, logic-level threshold
MOSFETs must be used in most applications. The only
exception is if low input voltage is expected (V
then, sub-logic level threshold MOSFETs (V
should be used. Pay close attention to the BV specifi cation
for the MOSFETs as well; most of the logic level MOSFETs
are limited to 30V or less.
Selection criteria for the power MOSFETs include the “ON”
resistance R
voltage and maximum output current. Miller capacitance,
C
usually provided on the MOSFET manufacturers’ data
sheet. C
along the horizontal axis while the curve is approximately
fl at divided by the specifi ed change in V
then multiplied by the ratio of the application applied V
to the Gate charge curve specifi ed V
operating in continuous mode the duty cycles for the top
and bottom MOSFETs are given by:
MILLER
Main Switch Duty Cycle
Synchronous
, can be approximated from the gate charge curve
MILLER
DS(ON)
is equal to the increase in gate charge
Switch Duty Cycle =
, Miller capacitance C
=
V
V
OUT
IN
DS
. When the IC is
DS
V
IN
. This result is
MILLER
GS(TH)
– V
V
IN
CC
OUT
IN
voltage.
, input
< 5V);
< 3V)
38351fc
DS
CC