NL10276BC26-02 NEC Electronics, NL10276BC26-02 Datasheet - Page 16

• Manufacturer Part Number: NL10276BC26-02
• Description: (NL10276BC26-01-02) LCD DOT MATRIX GRAPHIC DISPLAY MODULE
• Manufacturer: NEC Electronics

DataSheet4U.com
www.DataSheet4U.com
DataSheet
4
GENERAL CAUTION
16
U
.com
Next figures and sentence are very important, please understand these contents as follows.
(1) Caution when taking out the module
(2) Caution for handling the module
(3) Caution for the atmosphere
<1> Pick the pouch only, in taking out module from a carrier box.
<1> As the electrostatic discharges may break the LCD module, handle the LCD module with care against
<2>
<3> As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
<4> Do not pull the interface connectors in or out while the LCD module is operating.
<5> Put the module display side down on a flat horizontal plane.
<6> Handle connectors and cables with care.
<7> When the module is operating, do not lose CLK, Hsync, or Vsync signal. If any one of these signals is
<8> The torque of mounting screw should be 0.294 N·m (3 Kgf·cm) less.
<9> Input signal timing is regulated by a output part of DS90CF562 (NS) in LCD module. If see the distrubing
<1> Dew drop atmosphere should be avoided.
<2> Do not store and/or operate the LCD module in a high temperature and/or high humidity atmosphere.
<3> This module uses cold cathode fluorescent lamp. Therefore, the life time of lamp becomes short
<4> Do not operate the LCD module in a high magnetic field.
GENERAL CAUTION
electrostatic discharges. Peel protection sheet out from the LCD panel surface as slowly as possible.
pressure to the LCD module should be avoided.
cleaning.
lost, the LCD panel would be damaged.
display, make sure a signal timing of the output part of IC (DS90CF562) showed in OUTLINE Rear View,
and set the signal timing in a regulation range. Regarding DS90CF562 specification, get a data-sheet
of National Semiconductor corporation and refer to the data-sheet.
Storage in an electro-conductive polymer packing pouch and under relatively low temperature atmosphere
is recommended.
conspicuously at low temperature.
This figure is a mark that you will get hurt and/or the module will have damages when you make
a mistake to operate.
This figure is a mark that you will get hurt when you make a mistake to operate.
As the LCD panel and backlight element are made from fragile glass material, impulse and
DataSheet4U.com
NL10276BC26-01, 02