atsam9708 ATMEL Corporation, atsam9708 Datasheet - Page 13

• Manufacturer Part Number: atsam9708
• Description: Sound Synthesis Atsam9708 128-voice Integrated Sound Synthesizer
• Manufacturer: ATMEL Corporation

12. External Memory Timing
12.1
1772E–DRMSD–10-Apr-06
External Memory Overview
The following memories can be connected to the ATSAM9708:
DRAMs and SDRAMs cannot be connected at the same time. The type of dynamic RAM con-
nection is determined at power-up by sensing the level of pins RAS and CAS (see
on page 4
Eight-bit wide static RAM can be connected using the additional Ram Byte Select (RBS)
address signal. RBS allows access to two bytes of SRAM within one regular memory cycle,
thereby providing 16 bits of data. Eight-bit wide SRAM can be connected only under control of
WCS1. The selection 8 bits/16 bits is done by firmware.
ROM and static RAMs use linear addressing (address lines WA0 to WA26). DRAM and
SDRAMs use time-multiplexed addressing with a ROW/COL scheme (address lines DRA0 to
DRA11). Additionally, SDRAMs use the DRA0/DRA11 lines for configuration and the DRA10
line for auto precharge.
ROM/SRAMs and DRAM/SDRAM address line share the same pins of the ATSAM9708. The
timing is determined by the input signal DRAM. If DRAM is high at the beginning of a memory
cycle, this indicates DRAM/SDRAM access.
If only one type of memory is connected (i.e., SDRAM), then the DRAM signal can be hard-
wired. Otherwise, it should be derived from an external decoding of high-order address lines.
• ROM or Flash memories, 16 bits wide
• Static RAMs, 8 bits or 16 bits wide
• DRAMs, 16 bits wide
• SDRAMs, 16 bits wide
and
”Memory Type Configuration and Boot Configuration” on page
ATSAM9708
26).
Table 3-4
13