lt1002amj Linear Technology Corporation, lt1002amj Datasheet - Page 9

• Manufacturer Part Number: lt1002amj
• Description: Dual, Matched Precision Operational Amplifier
• Manufacturer: Linear Technology Corporation

APPLICATIONS
This circuit is also used as burn-in configuration for the
LT1002, with supply voltages increased to 20V.
Unless proper care is exercised, thermocouple effects,
caused by temperature gradients across dissimilar metals
at the contacts to the input terminals, can exceed the
inherent drift of the amplifier. Air currents should be
minimized, package leads should be short, the two input
leads should be as close together as possible and main-
tained at the same temperature.
Channel Separation
This parameter is defined as the ratio of the change in input
offset voltage of one amplifier to the change in output
voltage of the other amplifier causing the offset change.
At low frequencies the LT1002’s channel separation is an
almost unmeasurable 148dB. As frequency increases, pin
to pin capacitance of the package, between the output of
one amplifier and the inputs of the other, becomes domi-
nant. Since these pins are non-adjacent, the capacitance is
only 0.02pF. To maintain the LT1002’s excellent channel
separation at higher frequencies, the socket and PC board
capacitances should be minimized.
100 *
50k*
Test Circuit for Offset Voltage
and its Drift with Temperature
(10)
(11)
3
4
V
O
–
+
= 1000 V
LT1002
50k*
1/2
–15V
15V
U
14 (7)
12 (5)
OS
* RESISTORS MUST HAVE LOW
THERMOELECTRIC POTENTIAL.
13 (6)
INFORMATION
U
V
O
W
1002 TA05
U
10
–
+
1/2 LT1002
The device under test should be warmed up for three
minutes and shielded from air currents. Turn the device
180 to measure the noise of side B.
Power supplies
The LT1002 is specified over a wide range of power supply
voltages from 3V to 18V. Operation with lower supplies
is possible, down to 1.2V (two Ni-Cad batteries). How-
ever, with 1.2V supplies, the device is stable only in
closed loop gains of + 2 or higher (or inverting gain of one
or higher).
The V+ supply terminals are completely independent and
may be powered by separate supplies if desired (this
approach, however, would sacrifice the advantages of the
power supply rejection ratio matching). The V– supply
terminals are both connected to the common substrate
and must be tied to the same voltage. Both V – pins should
be used.
DEVICE
UNDER
TEST
0.1 F
100k
A
0.1Hz to 10Hz Noise Test Circuit
4.7 F
2k
PEAK TO PEAK NOISE MEASURED IN 10 SEC INTERVAL
24.3k
1/2 LT1002
–
+
VOLTAGE GAIN = 50,000
B
100k
0.1 F
2.2 F
4.3k
22 F
LT1002
110k
SCOPE
R
IN
1002 TA06
1
= 1M
1002fb
9