mcs7715 MosChip, mcs7715 Datasheet - Page 28
mcs7715
Manufacturer Part Number
mcs7715
Description
Usb 1.1 To Single Uart And Printer Port
Manufacturer
MosChip
Datasheet
1.MCS7715.pdf
(34 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
mcs7715CQ-GR
Manufacturer:
MOSCHIP
Quantity:
443
Part Number:
mcs7715CQ-GR
Manufacturer:
MOSCHIP
Quantity:
20 000
Page 28
MCS7715
USB 1.1 to Single UART and Printer Port
Vendor Specific Command Registers:
There are three vendor specific registers which are used to tune the behavior and performance of the UART
and Parallel Port. They are as follows
SP_REGISTER:
This register is used for internal debugging of UDC controller & bridge circuitry. This enables the designer to
pin point the problem in the design. This register also enables the hardware flow control. This register has
bits which clear the Bulk-In & Bulk-Out FIFOs. There is a bit which resets the UART. There are bits which
control the input clock fed to the UART, providing options for higher Baud Rates.
Register:
Description:
Offset:
Permissions:
Access Condition:
•
•
•
SP_REG
PP_REG
SP_CONTROL_REG
Clk_UART_Select: Changes the clock fed to the Serial Port as shown in the table below.
UART_Reset
Ser_line_err_ctl_en
Clk_UART_Select Changes the clock fed to UART as shown in the table below
UART_Reset
Sp_bo_clear
Bit[7]
Sp_bi_clear
Udc_loop
Bit
SP_REG
Serial Port Register
0x01
Read/Write
Application Number = 0x0000
Bit[6] Bit[5] Bit[4]
Clk_UART_Select
Option
3’b000
3’b001
3’b010
3’b100
3’b011
When enabled, loops the data from the Bulk-Out FIFO to the Bulk-In FIFO.
When enabled, will not allow the data from the UART to be written into the
Bulk-In FIFO if there are any errors in the received data.
Reset the Bulk-Out FIFO
Reset the Bulk-In FIFO
Resets the UART
Input Clock Frequency
Sp_bi_clear Sp_bo_clear Ser_line_err_ctl_en Udc_loop
Bit[3]
0.75 MHz
1.5 MHz
12 MHz
6 MHz
3 MHz
Description
Bit[2]
Bit[1]
Bit[0]
Rev. 1.6