psb21381 Infineon Technologies Corporation, psb21381 Datasheet - Page 100
psb21381
Manufacturer Part Number
psb21381
Description
Siemens Codec With S/t Transceiver
Manufacturer
Infineon Technologies Corporation
Datasheet
1.PSB21381.pdf
(270 pages)
- Current page: 100 of 270
- Download datasheet (4Mb)
Data Sheet
2.3.8
If MODE1.CFS is set to ’0’, the clocks are also provided in power down state.
If CFS is set to ’1’ only the analog level detector is active in power down state. All clocks,
including the IOM interface, are stopped (DD, DU are ’high’, whereas DCL is ’low’ and
BCL is ’high’).
If TR_CONF0.LDD is set to ’0’ an activation initiated from the exchange side will have
the consequence that the clock signals are provided automatically. If TR_CONF0.LDD
is set to ’1’ the microcontroller has to take care of an interrupt caused by the level detect
circuit (ISTATR.LD, see chapter 7.2.8).
From the terminal side an activation must be started by setting and resetting the SPU-
bit in the IOM_CR register and issuing the command TIM or by resetting MODE1.CFS=0.
2.3.9
The layer-1 part of the SCOUT can be enabled/disabled by configuration with the two
bits TR_CONF0.DIS_TR and TR_CONF2.DIS_TX (see chapter 7.2.3).
By default all layer-1 functions with the exception of the transmit buffers is enabled
(DIS_TR = ’0’, DIS_TX = ’1’). With several terminals connected to the S/T interface,
another terminal may keep the interface activated although the SCOUT does not
establish a connection. The receiver will monitor for incoming calls in this configuration.
If the transceiver is disabled (DIS_TR = ’1’) all layer-1 functions are disabled including
the level detection circuit of the receiver. In this case the power consumption of the layer-
1 is reduced to a minimum. All other functional blocks of the SCOUT can still operate via
IOM-2. The DCL and FSC pins become input.
Level Detection and Power Down
Transceiver Enable/Disable
90
PSB 21381/2
PSB 21383/4
Interfaces
2001-03-12
Related parts for psb21381
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Psb Series Extended Positive Switching Regulators Rugged
Manufacturer:
Power-One
Datasheet:
Part Number:
Description:
Psb Series Extended Positive Switching Regulator Industrial
Manufacturer:
Power-One
Datasheet:
Part Number:
Description:
Psb Series Extended Positive Switching Regulators Benign
Manufacturer:
Power-One
Datasheet:
Part Number:
Description:
Antenna Switch Silicon Pin Diode
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Silicon Switching Diodes
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Single Igbt Driver Ic
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Igbt Modules
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
5 Volt Standard Regulator
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Active Biased Transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
N-channel Small Signal Mosfet 20v?800v
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Sipmos Small-signal Transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Complementary Mosfets 60v Small-signal-transistor
Manufacturer:
Infineon Technologies Corporation
Datasheet:
Part Number:
Description:
Complementary Mosfets 60v
Manufacturer:
Infineon Technologies Corporation
Datasheet: