tda6612-2 Infineon Technologies Corporation, tda6612-2 Datasheet - Page 4
![no-image](/images/no-image-200.jpg)
tda6612-2
Manufacturer Part Number
tda6612-2
Description
Tv-stereo-sound
Manufacturer
Infineon Technologies Corporation
Datasheet
1.TDA6612-2.pdf
(47 pages)
center frequency of the filter is switched between "dual" and "stereo" by a multiplexer. The
multiplexing frequency is adjustable by software. If a side band is detected, the multiplexer stops.
The interferences on the first "detected" criterion are suppressed by a digital integrator with a
following comparator and can be read out via I
The control of the corresponding signal can be either directly internally or through the C. All the
necessary clock signal are derived from a fast setting PLL which is synchronized by a reference
frequency. This reference frequency must be sufficiently close to the horizontal frequency, but a
rigid phase coupling is not required. Therefore, alternatively the use of a crystal controlled 62.5-
kHz frequency commonly found in PLL-tuning systems is possible. A further alternative for the clock
signal generation is a build-in crystal oscillator with an external 4-MHz crystal or the use an external
1- or 4-MHz clock frequency.
Control Section
All functions are controlled via an I
currently used are stored in a block of latches.
The telegram structure is formed in the following manner:
start condition - chip address - any number of bytes - stop condition
The following conditions apply to the data bytes:
Before the actual data byte (with the adjustment information), always an I
has to be transmitted. The I
byte.
Example: The headphone volume is to be increased in a number of steps.
Right
Start condition
Chip address 84 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 8 08 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 9 09 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 10 0A (Hex)
Stop condition
Within a telegram (i.e. without a new start condition) any different sub-addresses can be accessed.
The changeover between "listen" and "talk" access to the IC however must always occur using the
following sequence: stop condition - start condition - chip address. Before each read access always
a start condition and chip address (talk) must be transmitted. The data to be read out are then
loaded into the I
Semiconductor Group
2
C Bus interface and can be transferred to the C.
2
C Bus interface however is interpreting this sub-address byte as a data
2
C Bus interface with "listen" / "talk" functions. The data bytes
Wrong
Start condition
Chip address 84 (Hex)
Sub-addr. vol. HP 03 (Hex)
Vol. step 8 08 (Hex)
Vol. step 9 09 (Hex)
Vol. step 10 0A (Hex)
Stop condition
2
C Bus (talk mode) as the "stereo" or "dual" mode.
4
2
C Bus sub-address byte
TDA 6612-2