at27c040 ATMEL Corporation, at27c040 Datasheet - Page 9

• Manufacturer Part Number: at27c040
• Description: 4-megabit 512k X 8 Otp Eprom
• Manufacturer: ATMEL Corporation

18. Rapid Programming Algorithm
0189H–EPROM–12/07
A 100 µs CE pulse width is used to program. The address is set to the first location. V
raised to 6.5V and V
CE pulse without verification. Then a verification/reprogramming loop is executed for each
address. In the event a byte fails to pass verification, up to 10 successive 100 µs pulses are
applied with a verification after each pulse. If the byte fails to verify after 10 pulses have been
applied, the part is considered failed. After the byte verifies properly, the next address is
selected until all have been checked. V
are read again and compared with the original data to determine if the device passes or fails.
PP
is raised to 13.0V. Each address is first programmed with one 100 µs
PP
is then lowered to 5.0V and V
CC
AT27C040
to 5.0V. All bytes
CC
is
9