at49bv802a ATMEL Corporation, at49bv802a Datasheet - Page 2

• Manufacturer Part Number: at49bv802a
• Description: 8-megabit 512k X 16/ 1m X 8 3-volt Only Flash Memory
• Manufacturer: ATMEL Corporation

2. Pin Configurations
2
AT49BV802A(T)
A six-byte command (Enter Single Pulse Program Mode) sequence to remove the requirement
of entering the three-byte program sequence is offered to further improve programming time.
After entering the six-byte code, only single pulses on the write control lines are required for writ-
ing into the device. This mode (Single Pulse Byte/Word Program) is exited by powering down
the device, or by pulsing the RESET pin low for a minimum of 500 ns and then bringing it back to
V
while in this mode; if entered they will result in data being programmed into the device. It is not
recommended that the six-byte code reside in the software of the final product but only exist in
external programming code.
The BYTE pin controls whether the device data I/O pins operate in the byte or word configura-
tion. If the BYTE pin is set at logic “1”, the device is in word configuration, I/O0 - I/O15 are active
and controlled by CE and OE.
If the BYTE pin is set at logic “0”, the device is in byte configuration, and only data I/O pins I/O0
- I/O7 are active and controlled by CE and OE. The data I/O pins I/O8 - I/O14 are tri-stated, and
the I/O15 pin is used as an input for the LSB (A-1) address function.
Pin Name
A0 - A18
CE
OE
WE
RESET
RDY/BUSY
I/O0 - I/O14
I/O15 (A-1)
BYTE
NC
CC
. Erase, Erase Suspend/Resume and Program Suspend/Resume commands will not work
Function
Addresses
Chip Enable
Output Enable
Write Enable
Reset
READY/BUSY Output
Data Inputs/Outputs
I/O15 (Data Input/Output, Word Mode)
A-1 (LSB Address Input, Byte Mode)
Selects Byte or Word Mode
No Connect
3405E–FLASH–2/07