is24c02a Integrated Silicon Solution, Inc., is24c02a Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
is24c02a
Manufacturer Part Number
is24c02a
Description
Serial Eeprom
Manufacturer
Integrated Silicon Solution, Inc.
Datasheet
1.IS24C02A.pdf
(22 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
is24c02a-25LI
Manufacturer:
AVAGO
Quantity:
547
IS24C02A IS24C04A IS24C08A IS24C16A
DEVICE OPERATIOn
IS24C02A/04A/08A/16A features serial communication
and supports a bi-directional 2-wire bus transmission
protocol called I
2-WIRE bUS
The two-wire bus is defined as a Serial Data line (SDA), and
a Serial Clock line (SCL). The protocol defines any device
that sends data onto the SDA bus as a transmitter, and
the receiving devices as receivers. The bus is controlled
by Master device that generates the SCL, controls the bus
access, and generates the Stop and Start conditions. The
IS24C02A/04A/08A/16A is the Slave device on the bus.
The bus Protocol:
– Data transfer may be initiated only when the bus is not
– During a data transfer, the SDA line must remain stable
The state of the SDA line represents valid data after a Start
condition. The SDA line must be stable for the duration of
the High period of the clock signal. The data on the SDA
line may be changed during the Low period of the clock
signal. There is one clock pulse per bit of data. Each data
transfer is initiated with a Start condition and terminated
with a Stop condition.
6
busy
whenever the SCL line is high. Any changes in the SDA
line while the SCL line is high will be interpreted as a
Start or Stop condition.
2
C
TM
.
Start Condition
The Start condition precedes all commands to the device
and is defined as a High to Low transition of SDA when
SCL is High. The EEPROM monitors the SDA and SCL
lines and will not respond until the Start condition is met.
Stop Condition
The Stop condition is defined as a Low to High transition
of SDA when SCL is High. All operations must end with
a Stop condition.
Acknowledge (ACK)
After a successful data transfer, each receiving device is
required to generate an ACK. The Acknowledging device
pulls down the SDA line.
Reset
The IS24C02A/04A/08A/16A contains a reset function
in case the 2-wire bus transmission is accidentally
interrupted (eg. a power loss), or needs to be terminated
mid-stream. The reset is caused when the Master
device creates a Start condition. To do this, it may be
necessary for the Master device to monitor the SDA line
while cycling the SCL up to nine times. (For each clock
signal transition to High, the Master checks for a High
level on SDA.)
Standby Mode
Power consumption is reduced in standby mode. The
IS24C02A/04A/08A/16A will enter standby mode: a) At
Power-up, and remain in it until SCL or SDA toggles; b)
Following the Stop signal if a no write operation is initiated;
or c) Following any internal write operation.
Integrated Silicon Solution, Inc. — www.issi.com
11/10/08
Rev. J