ata5279n ATMEL Corporation, ata5279n Datasheet - Page 19

• Manufacturer Part Number: ata5279n
• Description: Antenna Driver For Multiple Antennas
• Manufacturer: ATMEL Corporation

ATA5279N [Preliminary]
In this example, the output signal of the modulator resembles the illustration below.
Figure 3-14. Example of Data Transmission of Two Consecutive Commands
First Command
Second Command
Modulator Data
BCNT Signal
2
t
24
t
data
data
26
t
data
The value for t
depends on the speed setting of the modulator (32 LF-periods in standard and
data
22 periods in high speed mode, with one period being 8 µs when operating with 125 kHz output
frequency and therefore 8 MHz system clock).
The least amount of data that can be processed by the modulator stage is four LF bits or two
(e.g. Manchester-encoded) data bits. The first command in the upper example is a mini-
mum-length LF data command.
To ensure the traceability of the LF protocol, two pins are provided, which indicate an active data
transmission (MACT) and the change of an LF bit (BCNT).
Figure 3-13
illustrates the function of
these two signals:
Figure 3-15. LF Transmission Tracing Signals
Modulator Data
off
1
0
1
1
0
1
1
off
Transmitter Coil Current
Current Envelope
MACT Signal
BCNT Signal
The MACT signal can be used to start a timer whereas BCNT can be used as input signal to a
counter. Note that for carrier transmissions, only the MACT signal is active. There are not any
pulses on the BCNT line.
19
9125C–RKE–01/09