str-e1565 Sanken Electric Co., Ltd., str-e1565 Datasheet - Page 10

• Manufacturer Part Number: str-e1565
• Description: Pfc/dc-dc Systematic Combo Power Ic
• Manufacturer: Sanken Electric Co., Ltd.

PFC/DC-DC Systematic Combo Power IC
STR-E1565
Cautions for Storage
●
●
●
Cautions for characteristic Tests and Handling
When characteristic tests are carried out during inspection testing and other standard tests periods, protect the devices
from surge of power from the testing device, shorts between the devices and the heatsink.
Remarks in using silicone grease for a heatsink
When silicone grease is used in mounting this product on a heatsink, it shall be applied evenly and thinly. If more
silicone grease than required is applied, it may produce forced stress.
Volatile type silicone grease may produce cracks after elapse of long term, resulting in reducing heat radiation effect.
Silicone grease with low consistency (hard grease) may cause cracks in the mold resin when screwing the product to a
heatsink.
Recommended operating temperature
Inner frame temperature in operation TF=105 (°C)MAX.
Recommended Screw Torque
0.588 to 0.785[Ｎ･ｍ]（6～8[kgf･cm]）
Soldering Temperature
When soldering the products, please be sure to minimize the working time, within the following conditions.
●260±5°C
●350±5°C
Considerations to protect the Products from Electrostatic Discharge
●
●
●
●
●
Ensure that storage conditions comply with the standard temperature (5 to 35°C) and the standard relative humidity
Avoid locations where dust or harmful gases are present and avoid direct sunlight.
Reinspect for rust in leads and solderability that have been stored for a long time.
When handling the devices, operator must be grounded. Grounded wrist straps be worn and should have at least
Workbenches where the devices are handled should be grounded and be provided with conductive table and floor
When using measuring equipment such as a curve tracer, the equipment should also be grounded.
When soldering the devices, the head of a soldering iron or a solder bath must be grounded in other to prevent leak
The devices should always be stored and transported in our shipping containers or conductive containers, or be
(around 40 to 75%) and avoid storage locations that experience extreme changes in temperature or humidity.
1MΩ of resistance near operators to ground to prevent shock hazard.
mats.
voltage generated by them from being applied to the devices.
wrapped up in aluminum foil.
Since reliability can be affected adversely by improper storage environment and handling methods during
Characteristic tests, please observe the following cautions.
CAUTION / WARNING
3sec. (
10sec.
Soldering iron
）
Sanken Electric Co.,Ltd
10/13
.
I01-001EB-060302
September .
2005