ftlx8541f2 Finisar Corporation., ftlx8541f2 Datasheet - Page 8

• Manufacturer Part Number: ftlx8541f2
• Description: Rohs-6 Compliant 10 Gb/s 850nm Multimode X2 Transponder
• Manufacturer: Finisar Corporation.

FTLX8541 Product Specification – November 2007
Environmental Performance
Operating case temperature:
Operating humidity:
Fibers and Connectors
The transponder has SC receptacles for both Tx and Rx. The transponder is designed for
multimode SC cables, 0° polished endface (PC).
70-pin Connector
The module interface connector is a 70-pin, printed circuit board edge connection with a
0.5 mm pitch. The appropriate mating connector for the customer PCB is a 70-pin SMT,
dual row, right angled, edge connector, 0.5 mm pitch (Tyco Electronics part number
1367337-1, Molex part number 74441-0003 or equivalent).
Rail and Mechanical Mounting Requirements
The X2 rail system required to mount the X2 module is fully defined by the MSA.
(Tyco Electronics part number 1367608-1: designed for belly to belly applications;
and 1367610-1, designed for single sided board mount to fit into the standard host PCB
footprint; or equivalent). For further details please refer to vendor-supplied information.
Aqueous Wash
Finisar X2 transponders are neither solderable nor aqueous washable and are not
intended for these processes.
VI. Regulatory Compliance
Feature
ESD:
Electrostatic Discharge to the
Electrical Pins (HBM)
Immunity:
Against Electrostatic Discharge
(ESD) to the Module Receptacle
Immunity:
Against Radio Frequency
Electromagnetic Field
Emission:
Electromagnetic Interference
(EMI)
© Finisar Corporation – November 28, 2007 Rev. B
Standard
EIA/JESD22-A114-B
(MIL-STD 883D
Method 3015.7)
EN 61000-4-2
IEC 61000-4-2
EN 61000-4-3
IEC 61000-4-3
FCC 47 CFR
Part 15, Class B
EN 55022 Class B
CISPR 22
0°C to +70°C
0% -95% RH non-condensing
Comments
Class 1a (> 500 V)
Discharges ranging from
the front end / faceplate / receptacle cause no
damage to module (under recommended
conditions).
With a field strength of 10 V/m, noise
frequency ranges from 10 MHz to 2 GHz. No
effect on module performance between the
specification limits.
Noise frequency range:
30 MHz to 40 GHz
Radiated emission does not exceed specified
limits when measured with module inside a
shielding enclosure with a MSA conforming
cutout.
±
2 kV to
±
25 kV to
Page 8