pci304-1203 SL Power Electronics, pci304-1203 Datasheet - Page 2

• Manufacturer Part Number: pci304-1203
• Description: 300 Watts Power Factor Corrected Multiple Output
• Manufacturer: SL Power Electronics

SPECIFICATIONS:
INPUT
AC Input: 90 - 264 Vac continuous range, 47 to 63 Hz. Internally fused for 7 A.
Power Factor: 0.99 typical at full load. Meets EN61000-3-2.
Inrush: Cold start AC current limited to 20 A. at 115 Vac, 40 A. at 230 Vac. Limited by
Brownout Protection: Holds regulation to 85 Vac.
Holdup Time: 20 ms minimum.
Efficiency: 70% typical at full load nominal line.
AC Power Fail: Provides TTL “0” 5 ms before output goes out of regulation band upon loss of
OUTPUT
Adjustability: ± 5%
Line & Load Reg: ± 1% over AC input range and minimum to maximum load, V1, V2, & V3.
Minimum Load: 10% on main to insure regulation of aux outputs.
Ripple & Noise: Less than 1% p-p or 100 mV, which ever greater.
Remote Sense: (Outputs V1, and V4) Compensates for 500 mv total line drop. Open sense lead
Temperature Coefficient: 0.02% per degree C.
Transient Response: Output voltage returns to within 1% in less than 500 µs for a
Overload Protection: All outputs are protected against overload and short circuit.
Overvoltage Protection: Outputs V1, V2 & V3 protected against power supply induced over
Reverse Voltage: Protected against reversed voltage up to supply current ratings.
ENVIRONMENTAL
Thermal Protection: Shuts down power supply if overheated. Requires AC input to be recycled
Temperature Range: 0° C to 50° C. at full ratings.
Safety Agencies: Approved to UL 1950; CSA 22.2 # 234 (950); TUV EN60950,
Conducted RFI: Meets FCC part 15, Subpart J class A, and CISPR 22 class A.
Output Isolation: Isolated form ground 50Vdc.
Cooling: 30CFM required to achieve full ratings.
Cooling: Self-cooled by ball-bearing fan (F-option).
OPTIONS:
Option F: Integral ball-bearing fan
Consult factory for other available options.
thermistor.
input power.
V4 : ±2%
protection.
50 % load change. Peak transient does not exceed 5%.
Automatic recovery upon removal of fault.
voltage condition. Factory set to 125% maximum.
to reset.
Class 1 SELV; CE 72/23/EEC/93/68EEC (low voltage directive).
Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • [phone] Fax: [phone] http://www.condorpower.com
2.6 lbs 1.2 kgs
PCI-300
*Mates with AMP # 640440-5 with contact sockets
AC INPUT (90 - 264 VAC Continuous Range)
DC OUTPUT
STATUS AND CONTROL
TB-1 (L)
TB-1 (N)
TB-1 (GND)
Output #1
Output #2
Output #3
Output #4
Remote Sense
AC Power Fail
FUNCTION
FUNCTION
FUNCTION
TB-2-1,2 (+)
TB-2-3,4
TB-2-7 (+)
TB-2-8
TB-2-9 (-)
TB-2-8
TB-2-5
TB-2-6
Line
Neutral
Safety Ground
J3-1
J3-2
J3-4
J3-5
J3-3
PCI-300 with Option F
LOCATION
LOCATION
115 VAC
3.2 lbs 1.5 kgs
300 WATTS
10.23” x 5.50 x 2.19”
PCI 300
3.3v Sense Rtn
3.3v Sense
+5v Sense Rtn
+5 Sense
Reference to com
+5V Output
Rtn (Common)
+12V Output
Rtn (Common)
-12V Output
Rtn (Common)
+3.3V Output
Rtn
Line
Neutral
Safety Ground
230 VAC
NOTES
NOTES
Dimensions:
Barrier strip
#6-32 Screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
#6-32 screw
Barrier strip
# 6-32 screw
Barrier strip
#6-32 screw
Amp #640456-5*
Amp #640456-5
Amp #640456-5
Amp #640456-5
Amp #640456-5
CONNECTOR
CONNECTOR
CONNECTOR
Millimeters
Inches