jsh-85l3aa1-10 ETC-unknow, jsh-85l3aa1-10 Datasheet - Page 5

• Manufacturer Part Number: jsh-85l3aa1-10
• Description: Fibre Channel Compliant 1310 Limiting Transceiver
• Manufacturer: ETC-unknow

Power Supply Filter Component values
Component
L1, L2
Rx, Ry
C1, C5
C2, C3, C4
C6
Notes:
Option A is recommended for use in applications with space constraints. Power supply noise must be less than 100 mV
Option B is used in the module compliance board in SFF-8431.
*If the total series resistance of L1+C6 and L2+C5 exceeds the values of Rx and Ry in the table, then Rx and Ry can be omitted.
5
Power supply filtering is recommended for both the transmitter and receiver. Fil-
tering should be placed on the host assembly as close to the Vcc pins as possible for
optimal performance. V
Power supply filter component values from Figure 2 are shown in the table below
for two different implementations.
Option A
1.0
0.5*
10
0.1
Not required
8.5 G F IBRE CHANNEL COMPLIANT SFP+
1310 NM LIMITING TRANSCEI vER
cc,R
and V
cc ,T
Option B
4.7
0.5*
22
0.1
22
should have separate filters.
p-p
.
Units
μH
W
μF
μF
μF