la1k-32a2s IDEC Corporation, la1k-32a2s Datasheet - Page 21

• Manufacturer Part Number: la1k-32a2s
• Description: Switchnet? Hw Series Control Units
• Manufacturer: IDEC Corporation

Communication & Networking
Replacement of the Lens and
Marking Plate
Removal
To remove the operator (color lens, marking plate
and lens holder), hold the color lens recesses with
the lens removal tool (MT-101) and pull it out. Re-
move the marking plate by disengaging the latches
between the color lens and lens holder. Engrave a
legend on the correct side of the marking plate, if
required.
Installation
Place the marking plate on the lens holder in the
correct direction and press the color lens onto the
lens holder to engage the latches. Insert the lens
holder into the housing in the correct direction.
Replacement of LED Lamps
Lamps can be replaced using the lamp holder tool
(OR-44) from the front of the panel. The lamp can
also be replaced by removing the communication
block from the operator.
Color Lens
Recess
Engraving
Area
Marking Plate Lens Holder
Latches
USA: 800-262-IDEC
Replacement from Panel Front
Removal
1. Push and turn the LED lamp counterclockwise
2. Push the lamp head into the lamp holder and pull
Installation
1. First, insert the LED lamp into the lamp holder
2. Hold the LED lamp in the lamp holder tool as
3. Insert the LED lamp into the communication
using the lamp holder tool, then the LED lamp and
the lamp holder can be removed.
out the LED lamp from the rear of the lamp holder.
from the rear. The lamp can be pushed in using
the thinner end of the lamp holder tool.
shown below.
block. With the slit in the lamp holder aligned
with the contact pin inside, push in and turn
clockwise until the lamp holder is secured.
Lamp Holder
Lamp Holder Tool
Canada: 888-317-IDEC
Panel Mounting
Remove the communication block from the operator.
Insert the operator into the panel cut-out from the
front, then install the communication block to the
operator.
Removing/Installing the
Communication Block
With the yellow lever stop depressed in the direc-
tion of j, turn the lock lever in the direction of k
(opposite to the arrow on the communication block),
and pull out the communication block.
To install, align the TOP markings on the operator
and the communication block together, insert the
operator into the communication block and turn the
lock lever in the direction of l (the arrow on the
communication block).
Notes for Panel Mounting
Use the optional ring wrench (MT-001) to mount the
operator onto a panel. Tighten the locking ring to a
recommended torque of 0.88 N·m. Use of pliers or
excessive tightening will damage the locking ring.
SwitchNet L6 Series
Lever
l
k
Lever Stop
j
287