zfsm-201 California Eastern Laboratories, zfsm-201 Datasheet - Page 14

• Manufacturer Part Number: zfsm-201
• Description: Integrated Transceiver Modules For Zigbee / Ieee 802.15.4 Evaluation Kit Available Zfsm-201-kit-1
• Manufacturer: California Eastern Laboratories

PROCESSING
Wave Soldering
If a wave soldering process is required on the host boards due to the presence of leaded components, only a single wave
soldering process is encouraged.
Hand Soldering
Hand soldering is possible. Use a soldering iron temperature setting equivalent to 350°C, follow IPC recommendations/
reference document IPC-7711.
Rework
The FreeStar Pro Module can be unsoldered from the host board. Use of a hot air rework tool and hot plate for pre-heating
from underneath is recommended. Avoid overheating.
!Warning
warranty coverage.
Additional Grounding
Attempts to improve module or system grounding by soldering braids, wires, or cables onto the module RF shield cover
is done at the customers own risk. The numerous ground pins at the module perimeter should be sufficient for optimum
immunity to external RF interference.
AGENCY CERTIFICATIONS
FCC Compliance Statement (Part 15.19) Section 7.15 of RSS-GEN
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Warning (Part 15.21)
Changes or modifications not expressly approved by CEL could void the user’s authority to operate the equipment.
20 cm Separation Distance
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
OEM Responsibility to the FCC Rules and Regulations
The FreeStar Pro Module has been certified per FCC Part 15 rules for integration into products without further testing or
certification. To fulfill the FCC certification requirements, the OEM using the FreeStar Pro Module must ensure that the
information provided on the FreeStar Pro Label is placed on the outside of the final product. The FreeStar Pro Module is
labeled with its own FCC ID Number. If the FCC ID is not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to the enclosed module. This
exterior label can use wording such as the following: “Contains Transmitter Module FCC ID: W7Z-FSTARPRO” or “Contains
FCC ID: W7Z-FSTARPRO”
The OEM using the FreeStar Pro Module must only use the approved antenna, (PCB Trace Antenna) that has been certi-
fied with this module. The OEM using the FreeStar Pro Module must test their final product configuration to comply with
Unintentional Radiator Limits before declaring FCC compliance per Part 15 of the FCC rules.
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Never attempt a rework on the module itself, e.g. replacing individual components. Such actions will terminate
(Continued)
Page 14
ZFSM-201 Series