ten15-2410wi Traco Power, ten15-2410wi Datasheet - Page 2

• Manufacturer Part Number: ten15-2410wi
• Description: Dc/dc Converters
• Manufacturer: Traco Power

All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
http://www.tracopower.com
Input Specifications
Input current at no load
Input current at full load
Surge voltage
(100 msec. max.)
Conducted noise (input)
Output Specifications
Voltage set accuracy
Regulation
Ripple and noise (20 MHz Bandwidth)
Temperature coefficient
Output current limitation
Short circuit protection
Capacitive load
General Specifications
Temperature ranges
Derating
Humidity (non condensing)
Reliability, calculated MTBF (MIL-HDBK-217E @ +25°C, ground benign)
Isolation voltage (60 sec)
Isolation capacity
Isolation resistance
Switching frequency (fixed)
Remote On/Off:
Safety standards
Safety approvals
24 Vin;
24 Vin;
48 Vin;
48 Vin;
– Input variation Vin min. to Vin max.
– Load variation 10 – 100 %
– Operating
– Case temperature
– Storage
– Input/Output
– Input/Output
– Input/Output (500 VDC)
– On:
– Off:
– Off idle current:
single output models: 470 µF max.
other output models: 740 mA typ.
other output models: 370 mA typ.
dual output models: 220 µF max.
3.3 Vout models: 528 mA typ.
3.3 Vout models: 264 mA typ.
48 Vin models: 15 mA typ.
48 Vin models: 100 V max.
24 Vin models: 25 mA typ.
24 Vin models:
EN 55022 level A, FCC part 15, level A
±1 %
0.5 % max.
1 % max.
80 mVpk-pk max.
±0.02 % / K
>110 % of Iout max., foldback
indefinite (automatic recovery)
–40°C to +85°C
+100°C max.
–55°C to +125°C
3.5 %/K above 70°C
95 % rel H max.
>700’000 h
1‘500 VDC
1200 pF typ
>1’000 MOhm
330 kHz typ. (pulse width modulation)
2.5 ... 5.5 VDC or open circuit.
-0.7 ... 0.8 VDC or short circuit pin 2 and pin 6
10 mA max.
UL 60950-1, EN 60950-1, IEC 60950-1
CSA File No. 226037
http://directories.csa-international.org
50 V max.
DC/DC Converters
TEN 15WI
Page 2 of 3
15 Watt