TS18H SUNTAN [Suntan Capacitors], TS18H Datasheet - Page 7

• Manufacturer Part Number: TS18H
• Description: HIGH VOLTAGE CERAMIC CHIP CAPACITOR-SMD
• Manufacturer: SUNTAN [Suntan Capacitors]

TS18H
HIGH VOLTAGE CERAMIC CHIP CAPACITOR-SMD
4. Soldering
5.Cleaning
6.Breakaway PC Boards
7. Storage Conditions
The ceramic section and metal section combine to the MLCC. As the
poor heat conductivity of the ceramic section ,ceramic chip capacitors are
susceptible to thermal shock when exposed to rapid or concentrated
heating or rapid cooling, especialy for large s
When hand soldering,use a soldering iron with a maximum power of
25W and a maximum tip diameter of 1.0mm.The soldering iron should
not touch the capacitor directly .
The temperature difference between the components and cleaning process should not be greater than 100 .
In the case of ultrasonic cleaning, too much power output can cause excessive vibration of the PC board which
may lead to the cracking of the capacitor or the soldered portion, or decrease the terminal electrodes’ strength,
thus the following condition
Ultrasonic output :
Ultrasonic frequency: Below 40KHZ
Ultrasonic washing period: 5min or less
When splitting the PC board after mounting capacitors and other components, care is required so as not to give
any stresses of twisting to board.1. Be careful not to subject the capacitors to excessive mechanical shocks.
Board separation should not be done manually, but by using the appropriate devices.
To maintain the solderability of terminal electrodes and to keep the packaging material in good
condition,recommended conditions as the following:
Temperature: 5-40℃;
Even though MLCC are stored in a good condition ,the solderability of MLCC termimal electrodes will
decrease as time goes by, so components should be used within 6 months from the time of delivery.
Suntan
®
Technology Company Limited
Below20W/L
Humidity: 20-70% RH
Website: www.suntan.com.hk
Email: [e-mail]
Tel: [phone]
Fax: [phone]
Suntan
℃
®