ST7-EPB STMICROELECTRONICS [STMicroelectronics], ST7-EPB Datasheet - Page 13
![no-image](/images/no-image-200.jpg)
ST7-EPB
Manufacturer Part Number
ST7-EPB
Description
Programming board
Manufacturer
STMICROELECTRONICS [STMicroelectronics]
Datasheet
1.ST7-EPB.pdf
(15 pages)
ST7-EPB
Appendix B
●
●
●
●
●
●
●
●
Any tester, equipment, or tool used at any production step, or for any manipulation of
semiconductor devices, must have its shield connected to ground.
The product must be placed on a conductive table top, made of steel or clean
aluminum
MΩ/cm
ground isolated with a 1 MΩ resistor placed in series)
goods must be done at such a grounded worktable.
The worktable must be free of all non-antistatic plastic objects.
An antistatic floor covering grounded through a conductive ground cable (with serial
resistor between 0.9 and 1.5 MΩ) should be used.
It is recommended that you wear an antistatic wrist or ankle strap, connected to the
antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the powered-on
tool, touch the surface of the grounded worktable.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any manipulation of
parts.
2
)
Safety Requirements
, grounded through a ground cable
, or covered by an antistatic surface (superficial resistivity equal to or higher than 0.5
UM0028 Rev 4
(conductive cable from protected equipment to
. All manipulation of finished
Appendix B Safety Requirements
goods
www.st.com
13/15