ax88196 ASIX Electronics Corporation, ax88196 Datasheet - Page 11

• Manufacturer Part Number: ax88196
• Description: Non-pci 8/16-bit 10/100m Fast Ethernet Mac Controller With Embedded Memory
• Manufacturer: ASIX Electronics Corporation

AEN
or
/PSEN
Tab - 1 Local CPU bus interface signals group
2.2 MII interface signals group
RXD[3:0]
CRS
RX_DV
RX_ER
RX_CLK
COL
TX_EN
TXD[3:0]
TX_CLK
MDC
MDIO
Tab - 2 MII interface signals group
SIGNAL
AX88196
I/O/PU
TYPE
I/PD
O
O
O
I
I
I
I
I
I
I
PIN NO.
90 – 87
99 – 96
124
85
83
82
86
84
95
94
92
91
Receive Data : RXD[3:0] is driven by the PHY synchronously with
respect to RX_CLK.
Carrier Sense : Asynchronous signal CRS is asserted by the PHY
when either the transmit or receive medium is non-idle.
Receive Data Valid : RX_DV is driven by the PHY synchronously
with respect to RX_CLK. Asserted high when valid data is present on
RXD [3:0].
Receive Error : RX_ER ,is driven by PHY and synchronous to
RX_CLK, is asserted for one or more RX_CLK periods to indicate to
the port that an error has detected.
Receive Clock : RX_CLK is a continuous clock that provides the
timing reference for the transfer of the RX_DV,RXD[3:0] and
RX_ER signals from the PHY to the MII port of the repeater.
Collision : this signal is driven by PHY when collision is detected.
Transmit Enable : TX_EN is transition synchronously with respect to
the rising edge of TX_CLK. TX_EN indicates that the port is
presenting nibbles on TXD [3:0] for transmission.
Transmit Data : TXD[3:0] is transition synchronously with respect to
the rising edge of TX_CLK. For each TX_CLK period in which
TX_EN is asserted, TXD[3:0] are accepted for transmission by the
PHY.
Transmit Clock : TX_CLK is a continuous clock from PHY. It
provides the timing reference for the transfer of the TX_EN and
TXD[3:0] signals from the MII port to the PHY.
Station Management Data Clock : The timing reference for MDIO.
All data transfers on MDIO are synchronized to the rising edge of this
clock. MDC is a 2.5MHz frequency clock output.
Station Management Data Input / Output : Serial data input/output
transfers from/to the PHYs . The transfer protocol conforms to the
IEEE 802.3u MII specification.
Address Enable : The signal is asserted when the address bus is
available for DMA cycle. When negated (low), AX88196 an I/O slave
device may respond to addresses and I/O command.
PSEN : This signal is active low for 8051 program access. For I/O
device, AX88196, this signal is active high to access the chip. This
signal is for 8051 bus application only.
Local CPU BUS MAC Controller
11
ASIX ELECTRONICS CORPORATION
DESCRIPTION