ICS650R-27 Integrated Circuit Systems, ICS650R-27 Datasheet - Page 4

• Manufacturer Part Number: ICS650R-27
• Description: Networking Clock Source
• Manufacturer: Integrated Circuit Systems

MDS 650-27 D
External Components
The ICS650-27 requires a minimum number of external
components for proper operation.
Decoupling Capacitor
Decoupling capacitors of 0.01µF must be connected
between each VDD and GND (pins 4 and 6, pins 16
and 14), as close to the device as possible. For
optimum device performance, the decoupling capacitor
should be mounted on the component side of the PCB.
Avoid the use of vias in the decoupling circuit.
Series Termination Resistor
When the PCB trace between the clock outputs and the
loads are over 1 inch, series termination should be
used. To series terminate a 50Ω trace (a commonly
used trace impedance), place a 33Ω resistor in series
with the clock line as close to the clock output pin as
possible. The nominal impedance of the clock output is
20Ω.
Absolute Maximum Ratings
Recommended Operation Conditions
Integrated Circuit Systems, Inc.
Stresses above the ratings listed below can cause permanent damage to the ICS650-27. These ratings,
which are standard values for ICS commercially rated parts, are stress ratings only. Functional operation of
the device at these or any other conditions above those indicated in the operational sections of the
specifications is not implied. Exposure to absolute maximum rating conditions for extended periods can
affect product reliability. Electrical parameters are guaranteed only over the recommended operating
temperature range.
Supply Voltage, VDD
All Inputs and Outputs
Ambient Operating Temperature
Storage Temperature
Junction Temperature
Soldering Temperature
Ambient Operating Temperature
Power Supply Voltage (measured in respect to GND)
Parameter
●
525 Race Street, San Jose, CA 95126
Item
4
Crystal Information
The crystal used should be a fundamental mode (do
not use third overtone), parallel resonant. Crystal
capacitors should be connected from pins X1 to ground
and X2 to ground to optimize the initial accuracy. The
value of these capacitors is given by the following
equation:
In the equation, C
for a crystal with a 16pF load capacitance, two 20 pF
[(16-6) x 2] capacitors should be used.
Crystal caps (pF) = (C
Min.
+3.0
-40
-40 to +85°C
-65 to +150°C
7 V
-0.5 V to VDD+0.5 V
175°C
260°C
●
tel [phone]
L
is the crystal load capacitance. So,
Typ.
+3.3
Rating
L
Networking Clock Source
- 6) x 2
Max.
+3.6
+85
●
www.icst.com
Revision 070505
ICS650-27
Units
°C
V