LTM201M2-L01 Samsung, LTM201M2-L01 Datasheet - Page 41

• Manufacturer Part Number: LTM201M2-L01
• Description: Display Module
• Manufacturer: Samsung

11. General Precautions
MODEL
11.1 Handling
(b) Because the inverter uses high voltages, it should be disconnected from power
(c) Refrain from strong mechanical shock and / or any force to the module.
(d) Note that polarizer films are very fragile and could be damaged easily.
(e) Wipe off water droplets or oil immediately. If you leave the droplets for a long
(f) If the surface of the polarizer is dirty, clean it using absorbent cotton or soft cloth.
(g) Desirable cleaners are water, IPA (Isopropyl Alcohol) or Hexane.
(h) If the liquid crystal material leaks from the panel, it should be kept away
(i) Protect the Module from static, or the CMOS Gate Array IC would be damaged.
(j) Use finger-stalls with soft gloves in order to keep display clean during the
(k) Do not disassemble the Module.
(l) Do not pull or fold the lamp wire.
(m) Do not adjust the variable resistor located on the Module.
(n) Protection film for polarizer on the Module should be slowly peeled off just before use
(o) Pins of I/F connector should not be touched directly with bare hands.
(a) When the module is assembled, it should be attached to the system firmly
using all mounting holes. Be careful not to twist and bend the module.
In addition to damage, it may cause improper operation or damage to the module
and CCFT back light.
Do not press or scratch the surface harder than a HB pencil lead.
time, staining or discoloration may occur.
Do not use Ketone type materials (ex. Acetone), Ethyl alcohol, Toluene, Ethyl acid
or Methyl chloride. It might cause permanent damage to the polarizer due to chemical
reaction.
from the eyes or mouth . In case of contact with hands, legs or clothes, it must
be washed away with soap thoroughly.
incoming inspection and assembly process.
so that the electrostatic charge can be minimized.
source before it is assembled or disassembled.
LTM201M2-L01
Doc. No
06-D00-S-060928
Approval Specification
Approval Specification
Page
41/43