PCA9550 Philips Semiconductors, PCA9550 Datasheet - Page 6

• Manufacturer Part Number: PCA9550
• Description: 2-bit I2C LED driver with programmable blink rates
• Manufacturer: Philips Semiconductors

Philips Semiconductors
Acknowledge
The number of data bytes transferred between the start and the stop conditions from transmitter to receiver is not limited. Each byte of eight bits
is followed by one acknowledge bit. The acknowledge bit is a HIGH level put on the bus by the transmitter whereas the master generates an
extra acknowledge related clock pulse.
A slave receiver which is addressed must generate an acknowledge after the reception of each byte. Also a master must generate an
acknowledge after the reception of each byte that has been clocked out of the slave transmitter. The device that acknowledges has to pull down
the SDA line during the acknowledge clock pulse, so that the SDA line is stable LOW during the HIGH period of the acknowledge related clock
pulse, set-up and hold times must be taken into account.
A master receiver must signal an end of data to the transmitter by not generating an acknowledge on the last byte that has been clocked out of
the slave. In this event, the transmitter must leave the data line HIGH to enable the master to generate a stop condition.
2003 May 02
2-bit I
2
C LED driver with programmable blink rates
BY TRANSMITTER
DATA OUTPUT
DATA OUTPUT
BY RECEIVER
SCL FROM
MASTER
START condition
S
Figure 8. Acknowledgement on the I
1
2
6
not acknowledge
acknowledge
8
2
C-bus
9
clock pulse for
acknowledgement
PCA9550
Product data
SW00368