SX8634I05AWLTRT SEMTECH [Semtech Corporation], SX8634I05AWLTRT Datasheet - Page 72

• Manufacturer Part Number: SX8634I05AWLTRT
• Description: Low Power, Capacitive Button and Slider Touch Controller with Enhanced LED
• Manufacturer: SEMTECH [Semtech Corporation]

ADVANCED COMMUNICATIONS & SENSING
6.6.2
The SPM read can be done in any mode (Active, Doze, Sleep).
The SPM must always be read in blocks of 8 bytes. The sequence is described below:
The complete SPM can be read by repeating 16 times the cycles shown in Figure 55 using base addresses 0x00,
0x08, 0x10, …, 0x70, 0x78.
Revision 7_6, October 10
1. Set the I2C in SPM mode by writing “01” to SpmCfg[5:4] and SPM read access by writing ‘1’ to SpmCfg[3].
2. Write the SPM base address to SpmBaseAddr (The base address needs to be a value modulo 8).
3. Read the eight consecutive bytes from I2C address 0, 1, 2, …7
4. Terminate by writing “000” to SpmCfg[5:3].
SPM Read Sequence
(12 sensors) with Enhanced LED Drivers and Proximity Sensing
Figure 55: SPM Read Sequence
© 2010 Semtech Corp.
Low Power, Capacitive Button and Slider Touch Controller
72
DATASHEET
www.semtech.com
SX8634