PIC12F1840 MICROCHIP [Microchip Technology], PIC12F1840 Datasheet - Page 90

• Manufacturer Part Number: PIC12F1840
• Description: 8-Pin Flash Microcontrollers with nanoWatt XLP Technology
• Manufacturer: MICROCHIP [Microchip Technology]

PIC12F/LF1840
9.1.1
When global interrupts are disabled (GIE cleared) and
any interrupt source has both its interrupt enable bit
and interrupt flag bit set, one of the following will occur:
• If the interrupt occurs before the execution of a
FIGURE 9-1:
DS41441A-page 90
Instruction Flow
SLEEP instruction
- SLEEP instruction will execute as a NOP.
- WDT and WDT prescaler will not be cleared
- TO bit of the STATUS register will not be set
- PD bit of the STATUS register will not be
(INTCON reg.)
Note
Interrupt flag
GIE bit
Instruction
Fetched
Instruction
Executed
CLKOUT
cleared.
OSC1
1:
2:
3:
4:
PC
(1)
(2)
WAKE-UP USING INTERRUPTS
XT, HS or LP Oscillator mode assumed.
CLKOUT is not available in XT, HS or LP Oscillator modes, but shown here for timing reference.
T
GIE = 1 assumed. In this case after wake-up, the processor calls the ISR at 0004h. If GIE = 0, execution will continue in-line.
OST
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1
Inst(PC) = Sleep
Inst(PC - 1)
= 1024 T
PC
WAKE-UP FROM SLEEP THROUGH INTERRUPT
OSC
(drawing not to scale). This delay applies only to XT, HS or LP Oscillator modes.
Inst(PC + 1)
Sleep
PC + 1
Processor in
Sleep
PC + 2
Preliminary
T
OST (3)
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4
Interrupt Latency
Inst(PC + 2)
Inst(PC + 1)
• If the interrupt occurs during or after the execu-
Even if the flag bits were checked before executing a
SLEEP instruction, it may be possible for flag bits to
become set before the SLEEP instruction completes. To
determine whether a SLEEP instruction executed, test
the PD bit. If the PD bit is set, the SLEEP instruction
was executed as a NOP.
PC + 2
tion of a SLEEP instruction
- SLEEP instruction will be completely exe-
- Device will immediately wake-up from Sleep
- WDT and WDT prescaler will be cleared
- TO bit of the STATUS register will be set
- PD bit of the STATUS register will be cleared.
cuted
(4)
Dummy Cycle
PC + 2
 2011 Microchip Technology Inc.
Dummy Cycle
Inst(0004h)
0004h
Inst(0005h)
Inst(0004h)
0005h