AIC1525-0 AIC [Analog Intergrations Corporation], AIC1525-0 Datasheet - Page 8

• Manufacturer Part Number: AIC1525-0
• Description: USB High-Side Power Switch
• Manufacturer: AIC [Analog Intergrations Corporation]

n
n
l Thermal Shutdown
l Error Flag
l Current Limit
l
PIN DESCRIPTION
APPLICATION INFORMATIONS
PIN 1: CTL
PIN 2: FLG
An open-drained output of an N-channel MOSFET,
the FLG output is pulled low to signal the following
fault conditions: input undervoltage, output current
limit, and thermal shutdown.
The current limit threshold is preset internally. It
protects the output MOSFET switches from damage
due to undesirable short circuit conditions or excess
inrush current often encountered during hot plug-in.
The low limit of the current limit threshold of the
AIC1525 allows a minimum current of 0.5A through
the MOSFET switches. A current limit condition will
signal the error flag.
When the chip temperature exceeds 135 C, the
thermal shutdown function turns off MOSFET switch
and signals the error flag. A hysteresis of 10 C
prevents the MOSFET from turning back on until the
chip temperature drops to below 125 C.
A 0.1 F to 1 F bypass capacitor from IN to GND,
located near the device, is strongly recommended to
Supply Filtering
- TTL compatible control input. It
- An active-low and open-drain fault
controls the power switch turn-
on/turn-off.
AIC1525-1 and active low for
AIC1525-0.
flag output for power switch. It can
indicate current limit if CTL is
Active
High
for
l
l
l
PIN 3: GND
PIN 4: NC
PIN 5, 7: IN
PIN 6, 8: OUT - MOSFET switch output.
control supply transients. Without a bypass
capacitor, an output short may cause sufficient
ringing on the input (from supply lead inductance) to
damage internal control circuitry.
USB support dynamic attachment (hot plug-in) of
peripherals. A current surge is caused by the input
capacitance of downstream device. Ferrite beads are
recommended in series with all power and ground
connector pins. Ferrite beads reduce EMI and limit
the inrush current during hot-attachment by filtering
high-frequency signals.
Bulk capacitance provides the short-term transient
current needed during a hot-attachment event. With
a 33 F, 16V tantalum or 100 F, 10V electrolytic
capacitor mounted close to downstream connector
should provide transient drop protection.
The power circuitry of USB printed circuit boards
requires a customized layout to maximize thermal
dissipation and to minimize voltage drop and EMI.
Transient Droop Requirements
Short Circuit Transient
Printed Circuit Layout
- Chip power ground.
- Not internally connected.
- Power supply Input.
active. In normal mode operation,
it also can indicate thermal
shutdown or undervoltage.
AIC1525
8