MC33984CHFK FREESCALE [Freescale Semiconductor, Inc], MC33984CHFK Datasheet - Page 19

• Manufacturer Part Number: MC33984CHFK
• Description: Dual Intelligent High-current Self-protected Silicon High Side Switch (4.0 mOhm)
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

POWER SUPPLY
VPWR pin. Characteristics are provided from 6.0 to 20 V for
the device. The VPWR pin supplies power to internal
regulator, analog, and logic circuit blocks. The V
used for Serial Peripheral Interface (SPI) communication in
order to configure and diagnose the device. This IC
architecture provides a low quiescent current sleep mode.
Applying V
the Normal mode. The device will transit to Fail-safe mode in
case of failures on the SPI (watchdog timeout).
HIGH SIDE SWITCH: HS[0:1]
automotive loads with high inrush current, as well as motors
and all types of resistive and inductive loads. This N-channel
MOSFET with 4.0 mΩ RDS(ON), is self-protected and each
N-channel presents extended diagnostics in order to detect
Analog Integrated Circuit Device Data
Freescale Semiconductor
The 33984 is designed to operate from 4.0 to 28 V on the
Those pins are the high side outputs controlling multiple
PWR
and V
DD
to the device will place the device in
INTERFACE
MCU
FUNCTIONAL INTERNAL BLOCK DESCRIPTION
DD
MCU INTERFACE AND
PARALLEL CONTROL
supply is
OUTPUT CONTROL
POWER SUPPLY
SPI INTERFACE
INPUTS
load disconnections and short-circuit fault conditions. The
HS[0:1] outputs are actively clamped during a turn-off of
inductive loads.
MCU INTERFACE AND OUTPUT CONTROL
MCU through the SPI. With a dedicated SPI command, it is
possible to independently turn on and off several loads that
are PWM’d at the same frequency, and duty cycles with only
one PWM signal. An analog feedback output provides a
current proportional to each load current. The SPI is used to
configure and to read the diagnostic status (faults) of the high
side output. The reported fault conditions are: open load,
short-circuit to ground (OCLO-resistive and OCHI-severe
short-circuit), thermal shutdown, and under/over-voltage.
parallel input pins. The device is configured in default mode.
In Normal mode, the loads are controlled directly from the
In Fail-safe mode, the loads are controlled with dedicated
HIGH SIDE SWITCH
SELF-PROTECTED
FUNCTIONAL INTERNAL BLOCK DESCRIPTION
HS [0:1]
FUNCTIONAL DESCRIPTION
33984
19