TS339CS TSC [Taiwan Semiconductor Company, Ltd], TS339CS Datasheet - Page 3

• Manufacturer Part Number: TS339CS
• Description: Quad Voltage Comparator
• Manufacturer: TSC [Taiwan Semiconductor Company, Ltd]

TS339
Electrical Characteristics (Continues)
Note 1. The maximum output current may be as high as 20mA, independent of the magnitude of V
Note 2. This magnitude of input current will only occur if the leads are driven more negative than ground or the
Note 3. At the output switch point, V
Note 4. The bias current flows out of the inputs due to the PNP input stage. This current is virtually constant,
Note 5. The response time specified is for a 100mV input step with 5mV overdrive For larger signals, 300ns is typical.
Note 6. Positive excursions of input voltage may exceed the power supply level. As long as one of the inputs remain
Note 7. The comparator will inhibit proper output state if one of the inputs is become greater than V
circuits to V
negative supply voltage. This is due to the input PNP collector base junction become forward biased, acting as
an input clamp diode. There is also a lateral PNP parasitic transistor action which can cause the output voltage of
the comparators to go to the V
driven negative. This will not destroy the device when limited to the max rating and normal output states will
recover when the inputs become ≥ground or negative supply.
common-mode range (0Vdc to V
independent of the output state.
within the common-mode range, the comparator will provide the proper output state.
must remain within the common mode range. The low input state must not be less than -0.3volts of ground of
minus supply.
CC
can cause excessive heating and eventual destruction.
CC
CC
voltage level (or ground if overdrive is large) during the time that an input is
O
-1.5Vdc).
=1.4Vdc, R
3-6
S
≤100Ω, 5.0Vdc≤ V
CC
≤30Vdc, with the inputs over the full
2003/12 rev. A
CC,
CC
the other input
Output short