LM29150 HTC [HTC Korea TAEJIN Technology Co.], LM29150 Datasheet - Page 10

• Manufacturer Part Number: LM29150
• Description: 1.5A Very L.D.O Voltage Regulator
• Manufacturer: HTC [HTC Korea TAEJIN Technology Co.]

1.5A Very L.D.O Voltage Regulator
Capacitor Requirements
Minimum Load Current
Adjustable Regulator Design
Error Flag
Nov. 2009 - Rev. 1.2
For stability and minimum output noise, a capacitor on the regulator output is necessary. The value of this
capacitor is dependent upon the output current; lower currents allow smaller capacitors. LM29150
regulators are stable with the 10uF minimum capacitor values at full load. Where the regulator is powered
from a source with a high AC impedance, a 0.1uF capacitor connected between input and GND is
recommended. This capacitor should have good characteristics to above 250kHz.
The LM29150 regulators are specified between finite loads. If the output is too small, leakage currents is too
small, leakage currents dominate and the output voltage rises. The 5mA minimum load current swamps any
expected leakage current across the operating temperature range.
The adjustable regulator versions, LM29152 allows programming the output voltage anywhere between
1.25V and the 26V maximum operating rating of the family.
Two resistors are used. Resistors can be quite large, up to 1MΩ, because of the very high input impedance
and low bias current of the sense comparator: The resistor values are calculated by:
Where V
varying load currents may scale the resistors to draw the minimum load current required for proper
operation.
LM29151 versions feature and Error Flag, which looks at the output voltage and signals and error condition
when this voltage and signals an error condition when this voltage drops 5% below its expected value. The
error flag is an open-collector output that pulls low under fault conditions. It may sink 10mA. Low output
voltage signifies a number of possible problems, including an over-current fault (the device is in current
limit) and low input voltage. The flag output is inoperative during over temperature shutdown conditions.
OUT
is desired output voltage, Figure 2 shows component definition. Applications with widely
V
IN
Figure 2. Adjustable Regulator with Resistors
C
IN
+
V
OUT
= 1.240 x [1 + (R1/R2)]
R
VIN
EN
1
=R
GND
( 2
V
V
- 10
OUT
OUT
REF
ADJ
-
-
) 1
R1
R2
+
C
OUT
LM29150/29151/29152
V
OUT
HTC