MAX8526 MAXIM [Maxim Integrated Products], MAX8526 Datasheet
MAX8526
Available stocks
Related parts for MAX8526
MAX8526 Summary of contents
Page 1
... Rev 1; 5/05 General Description The MAX8526/MAX8527/MAX8528 low-dropout linear regulators operate from input voltages as low as 1.425V and are able to deliver continuous output current with a maximum dropout voltage of only 200mV. The output voltage can be set from 0. and is 1.4% accurate over load and line variations, from 0° ...
Page 2
Input, 2A, 0.2V Dropout LDO Regulators ABSOLUTE MAXIMUM RATINGS IN, EN, POK (MAX8527), POR (MAX8528 GND ........................................................-0.3V to +4.0V OUT to GND ..................................................-0.3V to (IN + 0.3V) Output Short-Circuit Duration.....................................Continuous Continuous Power Dissipation (T = ...
Page 3
ELECTRICAL CHARACTERISTICS (continued) (Circuit of Figure +1.8V OUT PARAMETER GND V IN GND Supply Current Dropout, V GND Shutdown Current V IN POK (MAX8527 only Power-OK Threshold V HYS POK Output Voltage Low ...
Page 4
... LOAD 300 LOAD 200 100 0 2400 0 0.6 1.2 1.8 2.4 3.0 INPUT VOLTAGE (V) LINE-TRANSIENT RESPONSE (V = 1.8V TO 2.5V 2A) IN OUT MAX8526/27/28 toc06 100µs/div 2000 SHUTDOWN RESPONSE MAX8526/27/28 toc08 V OUT 1V/div I IN 2A/div EN 2V/div 100µs/div 3.6 V OUT 10mV/div AC-COUPLED V IN 500mV/div AC-COUPLED ...
Page 5
... V = +1.8V OUT PSRR vs. FREQUENCY (MAX8526 100mA LOAD -10 0.01 0 FREQUENCY (kHz) OUTPUT RIPPLE VOLTAGE 10µs/div SHORT-CIRCUIT CURRENT 40µs/div _______________________________________________________________________________________ 1.425V to 3.6V Input, 2A, 0.2V Dropout LDO Regulators Typical Operating Characteristics (continued) = +1.5V 2A, C =10µF, C OUT ...
Page 6
... Exposed Pad IN OVERTHERMAL PROTECTION REF SHUTDOWN EN LOGIC MAX8526 MAX8527 MAX8528 GND 6 _______________________________________________________________________________________ NAME Enable Input. Set low to place the device in low-current shutdown mode. Set EN high for normal operation. Regulator Input. V can range from 1.425V to 3.6V. Bypass with a 2.2µ higher ceramic capacitor to GND ...
Page 7
... PNP-based regulators also waste considerable current in dropout when the pass transistor saturates, and use high base-drive currents under large loads. The MAX8526/ MAX8527/MAX8528 do not suffer from these problems and consume only 500µA (typ) of quiescent current under heavy loads, as well as in dropout ...
Page 8
... The MAX8526/ MAX8527/MAX8528 load-transient response graphs (see the Typical Operating Characteristics) show two components of the output response shift from the output impedance due to the load current change, and the transient response ...
Page 9
For the latest package outline information go to www.maxim-ic.com/packages Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in ...