93AA86A MICROCHIP [Microchip Technology], 93AA86A Datasheet - Page 11

• Manufacturer Part Number: 93AA86A
• Description: 16K Microwire Compatible Serial EEPROM
• Manufacturer: MICROCHIP [Microchip Technology]

2.9
The Write All (WRAL) instruction will write the entire
memory array with the data specified in the command.
The self-timed auto-erase and programming cycle is
initiated by the rising edge of CLK on the last data bit.
Clocking of the CLK pin is not necessary after the
device has entered the WRAL cycle. The WRAL
command does include an automatic ERAL cycle for
the device. Therefore, the WRAL instruction does not
require an ERAL instruction, but the chip must be in the
EWEN status.
FIGURE 2-7:
© 2005 Microchip Technology Inc.
CLK
DO
CS
DI
Write All (WRAL)
93AA86A/B/C, 93LC86A/B/C, 93C86A/B/C
1
High-Z
WRAL TIMING
0
0
0
1
x
•••
x
The DO pin indicates the Ready/Busy status of the
device if CS is brought high after a minimum of 250 ns
low (T
V
Dx
CC
Note:
Note:
must be
CSL
•••
).
D0
The write sequence requires a logic high
signal on the PE pin prior to the rising
edge of the last data bit.
After the Write All cycle is complete,
issuing a Start bit and then taking CS low
will clear the Ready/Busy status from DO.
4.5V for proper operation of WRAL.
T
CSL
T
WL
Busy
T
SV
Ready
DS21797G-page 11
High-Z
T
CZ