TNY375-380 POWERINT [Power Integrations, Inc.], TNY375-380 Datasheet - Page 16

• Manufacturer Part Number: TNY375-380
• Description: Energy-Efficient, Off-Line Switcher With Enhanced Peak Power Performance
• Manufacturer: POWERINT [Power Integrations, Inc.]

Rev. A 05/07
NOTES:
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
16
For all BP/M pin capacitor values.
conditions. Total device consumption at no-load is the sum of I
Since the output MOSFET is switching, it is difficult to isolate the switching current from the supply current at the DRAIN. An
alternative is to measure the BP/M pin current at 6.1 V.
BP/M pin is not intended for sourcing supply current to external circuitry.
To ensure correct current limit, it is recommended that nominal 0.1 mF / 1 mF / 10 mF capacitors are used. In addition, the BP/M
capacitor value tolerance should be equal to or better than indicated below across the ambient temperature range of the target
application. The minimum and maximum capacitor values are guaranteed by characterization.
For current limit at other di/dt values, refer to Figure 24. Measurements made with device self-biased.
This parameter is derived from characterization.
This parameter is derived from the change in current limit measured at 1X and 4X of the di/dt shown in the I
typical specification under worst-case application conditions (rectified 265 VAC) for no-load consumption calculations.
Breakdown voltage may be checked against minimum BV
exceeding minimum BV
Auto-restart on time has the same temperature characteristics as the oscillator (inversely proportional to frequency).
I
I
Nominal BP/M
S1
DSS1
Pin Cap Value
is an accurate estimate of device controller current consumption at no-load, since operating frequency is so low under these
0.1 mF
is the worst-case OFF state leakage specification at 80% of BV
10 mF
1 mF
TNY375-380
DSS
Tolerance Relative to Nominal
-60%
-50%
-50%
Min
.
Capacitor Value
+100%
+100%
Max
NA
DSS
specification by ramping the DRAIN pin voltage up to but not
S1
and I
DSS
DSS2
and maximum operating junction temperature. I
.
LIMIT
specification.
www.powerint.com
DSS2
is a