MC9S08AC128_09 FREESCALE [Freescale Semiconductor, Inc], MC9S08AC128_09 Datasheet - Page 26
![no-image](/images/no-image-200.jpg)
MC9S08AC128_09
Manufacturer Part Number
MC9S08AC128_09
Description
MC9S08AC128 8-Bit Microcontroller Data Sheet
Manufacturer
FREESCALE [Freescale Semiconductor, Inc]
Datasheet
1.MC9S08AC128_09.pdf
(40 pages)
3
4
5
6
7
8
9
Chapter 3 Electrical Characteristics and Timing Specifications
26
Loss of reference frequency is the reference frequency detected internally, which transitions the ICG into self-clocked mode if it
is not in the desired range.
Loss of DCO frequency is the DCO frequency detected internally, which transitions the ICG into FLL bypassed external mode (if
an external reference exists) if it is not in the desired range.
This parameter is characterized before qualification rather than 100% tested.
Proper PC board layout procedures must be followed to achieve specifications.
This specification applies to the period of time required for the FLL to lock after entering FLL engaged internal or external modes.
If a crystal/resonator is being used as the reference, this specification assumes it is already running.
Jitter is the average deviation from the programmed frequency measured over the specified interval at maximum f
Measurements are made with the device powered by filtered supplies and clocked by a stable external clock signal. Noise
injected into the FLL circuitry via V
a given interval.
See
Figure 3-9
Figure 3-9. Internal Oscillator Deviation from Trimmed Frequency
Average of Percentage Error
DDA
and V
MC9S08AC128 Series Data Sheet, Rev. 2
SSA
and variation in crystal oscillator frequency increase the C
Variable
Freescale Semiconductor
3 V
5 V
Jitter
percentage for
ICGOUT
.