LP2980 National Semiconductor, LP2980 Datasheet - Page 15

• Manufacturer Part Number: LP2980
• Description: Micropower 50 mA Ultra Low-Dropout Regulator
• Manufacturer: National Semiconductor

Typical Applications
brought low, the converter will be in shutdown, and will draw
less than 1 µA from the source.
Notes:
A. Drive this input with a logic signal (see Application Hints).
If the shutdown function is not to be used, tie the ON/OFF
pin directly to the V
B. Capacitor is required for regulator stability. Minimum size
is shown, and may be increased without limit.
C. Increasing the output capacitance improves transient re-
sponse and increases phase margin.
D. A heatsink may be required for this transistor. The maxi-
mum allowable value for thermal resistance of the heatsink
is dependent on ambient temperature and load current (see
curves in ). Once the value is obtained from the graph, a
heatsink must be selected which has a thermal resistance
equal to or lower than this value. If the value is above
60˚C/W, no heatsink is required (the TO-220 package alone
will safely dissipate this).
For these curves, a maximum junction temperature of 150˚C
is assumed for the pass transistor. The case-to-heatsink at-
IN
pin.
(Continued)
15
tachment thermal resistance is assumed to be 1.5˚C/W. All
calculations are for 5.5V input voltage (which is worst-case
for power dissipation).
FIGURE 8. Heatsink Thermal Resistance Requirements
for Figure 7
DS012078-54
www.national.com